Safe Use of Spindle Moulders

Why should loose clothing and jewellery be avoided when operating a spindle moulder?

• They can get dirty easily

• They may get caught in moving parts, causing injury

• They are not fashionable in the workshop

• They make you look unprofessional

How often should the spindle moulder’s cutters be checked for sharpness and damage?

• Once a year

• Before each use

• Only when performance drops

• Never

What is the correct way to handle and store spindle moulder cutters?

• Leave them on the workbench

• Store them in a designated, secure container

• Place them in your pocket

• Leave them attached to the machine

Which of the following is a safe material handling technique when using a spindle moulder?

• Feed material with your hands close to the cutter

• Use push sticks or blocks to guide material

• Hold material loosely

• Feed material from the back of the machine

What should you do if a piece of material becomes jammed in the spindle moulder?

• Try to remove it with your hands while the machine is running

• Turn off and isolate the machine before attempting to clear the jam

• Ignore it and continue working

• Hit the machine to dislodge the material

How should you check that the spindle moulder is safe to use before starting work?

• Assume it is safe if it was used yesterday

• Inspect all guards, emergency stops, and electrical connections

• Only check the power switch

• Ask a friend if it looks alright

What is the recommended action if you notice a strange noise or vibration while operating the spindle moulder?

• Ignore it and continue working

• Stop the machine and report the issue to your supervisor

• Turn up the radio to drown out the noise

• Hit the machine to stop the noise

Why is it important to keep the work area around the spindle moulder clean and free from obstructions?

• To make the workshop look tidy

• To prevent slips, trips, and falls, and ensure safe operation

• To impress visitors

• To avoid dust on your clothes

Which of the following is considered an operational best practice when using a spindle moulder?

• Adjusting the cutter while the machine is running

• Setting the correct speed and feed rate for the material

• Using the machine without any training

• Removing guards for better visibility

What should you do after finishing work with the spindle moulder?

• Leave the machine running for the next person

• Turn off and isolate the machine, clean the area, and store tools properly

• Walk away without cleaning up

• Leave cutters attached to the spindle