FINAL OBJEKTIF TOF -20Q (PART 1)

A Wash-In wing is a wing that is twisted with the angle of incidence:

A) Same angle as for both the wing root and wing tip

B) Greater at the wing tip than the wing root

C) Greater at the wing root than the wing tip

• A

• B

• C

An aircraft having a high aspect ratio wing will be:

A) Unstable and less manoeuvrable

B) More stable but less manoeuvrable

C) Less stable but more manoeuvrable

• A

• B

• C

At what mode of operation are the flight spoilers being deployed simultaneously at both wings?

A) ground mode

B) roll mode

C) speedbrake mode

• A

• B

• C

Centre of gravity of an aeroplane can be determined using a percentage of:

A) Mean aerodynamic chord line

B) Mean camber line

C) Longitudinal axis line

• A

• B

• C

During a coordinated turn or banking, the aeroplane altitude dropped. What should the pilot do to maintain the flight level?

A) rotate the control wheel and apply more throttle

B) press the applicable rudder pedal and apply less throttle

C) pull the control column and apply more throttle

• A

• B

• C

During a right banking, if the aircraft start to reduce its altitude, what can the pilot do to correct it?

A) turn the control wheel to the right

B) push the right rudder pedal

C) pull the control yoke

• A

• B

• C

Dutch roll involves movement of the aeroplane about both the:

A) longitudinal and lateral axis

B) lateral and vertical axis

C) vertical and longitudinal axis

• A

• B

• C

For an aeroplane using power flying control unit (PFCU), the trimming of the primary flight control is through the use of:

A) trim actuator

B) trim tab

C) balance tab

• A

• B

• C

How do slots assist in increasing the lift of an aircraft?

A) increasing the area of the wing

B) decreasing the camber on the upper wing

C) delay airflow separation at high angle of attack

• A

• B

• C

If an aeroplane has a low aspect ratio wings, you can expect the wings to be:

A) long and slender

B) short and stubby

C) slim and narrower

• A

• B

• C