WorksheetsUnit 309 practice
Total questions: 20
Worksheet time: 10mins
in which document is the minimum width for disabled access found
Job Sheet
Cutting sheet
Building regulations
Construction regulations
what information is required to set out a segmental bay window
Span and rise
Rise and major axis
Minor axis and span
Minor and major axis
which one of the following angles can be drawn using standard set squares?
55 dergees
65 degrees
75 degrees
85 degrees
What is used to set out semi-elliptical headed door frame?
Set square
French curves
Trammel frames
Trammel heads
which must be produced when setting-out a shaped door?
Scaled hight sections
Full size hight sections
Full size elevations and sections
Half size elevations and sections
Full size patterns are required when setting out
Flight of stairs
Kitchen base units
Gothic headed door
Square headed door
Which one of the following construction methods is shown in the image
Solid.
Built up.
Laminated.
Post formed.
What joint is shown at X in the image?
Built up.
Dovetailed key.
Hammer headed key joint.
Hammer headed tenon joint
What material is a dovetail key made from?
Plastic
Aluminium
Hardwood.
Softwood
Which three of the following are required to complete a cutting list for a shaped headed
door?
Component length.
Full size elevation
Joint details.
Timber species
If a discrepancy is identified on a construction drawing following a site survey, who will
rectify this?
Client
Joiner
Architect
Machinist.
When cutting curved components for a semi-circular headed door, the template should
be applied on the timber to avoid
knots and short grain
knots and long grain
sapwood and long grain
heartwood and short grain
What is adjusted to allow a number of jambs to be cut to the same length?
Riving knife
Fence stop.
Depth gauge.
Tilting arbor.
When planing materials to width on a thicknesser it is best to start with the
longest length
shortest length
widest dimension
narrowest dimension.
Which one of the following provides recommendations on the safe use of spindle
moulder jigs?
Building regulations.
Construction regulations.
Approved Code of Practice
Approved document K.
What clearance gap should be maintained between the auger and the hollow square
chisel on a mortice machine?
0 - 0.5 mm.
1.5 - 2.5 mm.
3.5 - 4.5 mm.
4.5 - 5.5 mm.
Which two of the following operations can be cut on the band saw?
Haunches in stiles.
Stub mortices in rails.
Wedges to secure tenons.
Tenon cheeks on rails.
When setting up a spindle moulding machine, which one of the following tooling blocks
must be used?
Ball race.
Chip limiting.
Slotted collar.
French head.
At what stage are the joints for a semi-circular headed door checked for accuracy?
Dry fitting.
Marking out.
Setting out.
Final assembly.
To ensure the correct final shape of a gothic headed door frame it should be assembled
over the:
templates
spindle jig
.
full size rod
scaled drawing
