Place the convex or concave edge or face against the fence table.

The depth of cut is adjusted by moving the_____table up or down this is also the table you start feeding your stock into.

the fence tilting handwheel is used to adjust____angles.

Maximum depth of cut for edge jointing____inches and face jointing____inches.

A________should be used for short stock and in finishing the end of long stock as it passes over cutter head

The____table should only be adjusted be a qualified person

When finished jointing your stock it is your responsibility to make sure the____is stopped before leaving the machine.

The stock should be feed into the jointer so the machine is cutting____the grain and not____ the grain or____grain

The jointer should never be operated with the____ removed

the jointer is used to____ edge boards

When jointing, the stock should be held flat against the____ to achieve a straight edge

To ensure the edge and face of the stock are square to each other check that the table and fence are perpendicular with each other using a____

The minimum margin of safety is____ inches when jointing a board

Your____should NEVER run directly over the cutte head