A sensor used to measure rotational speed, including wheel speed, vehicle speed, engine speed, and camshaft and crankshaft position.

A switch connected between the ECM and a battery positive.

A circuit used for safety reasons that is used to verify throttle position.

A sensor that detects oxygen ions originating from nitric oxide from among the other oxygen ions present in the exhaust gas.

A switch connected between the ECM and a negative ground current potential.

A precisely regulated voltage supplied by the ECM to sensors; the value is typically 5 VDC, but some manufacturers use 8 or 12 volts.

A sensor that uses a current supplied by the ECM to operate.

A temperature-sensitive variable resistor commonly used to measure coolant, oil, fuel, and air temperatures.

A variable resistor with three connections— one at each end of a resistive path, and a third sliding contact that moves along the resistive pathway.

A sensor commonly used to measure the rotational speed of a shaft; they have the advantage of producing a digital signal square waveform and have strong signal strength at low shaft rotational speeds.

variable capacitance and strain gauge restistive would be types of ________________ sensors.

All of the following are correct concerning hall effect sensors EXCEPT?

All of the following are correct concerning voltage generators EXCEPT?

An ammonia sensor would be located _____________?

On a diesel engine, the MAF sensor is used to _____________.

Which of the following is correct concerning sensors that use Vref?

A ZVR wire can also be called a _____________ by some manufacturers.

thermistors are __________ type devices?

Which of the following is correct related to MAF sensors?