NEW
Font size
WorksheetsMMM batch 2
Total questions: 10
Worksheet time: 13mins
P-I, Q-III, R-IV, S-II
P-I, Q-IV, R-III, S-II
P-II, Q-III, R-IV, S-I
P-II, Q-IV, R-III, S-I
0.04
0.05
0.10
0.11
The group of Geometric Tolerances applied to individual features are known as
Positional tolerances
Orientation tolerances
Form tolerances
Run out
What is the value of the International Tolerance of 8th Grade
16i
25i
40i
64i
The closeness of agreement between a test result and the accepted reference value is called _____
Precision
Accuracy
Traceability
None of the above
Least count of a Universal Bevel Protractor is
1/12th of a degree
5'
Both 1/12th of a degree and 5'
10'
The maximum diameter of hole is its __________material condition
minimum
maximum
maximum and minimum
none of these
_______________ is an orientation geometric tolerance
Angularity
Cylindricity
Parallelism
Flatness
A screw gauge has 100 divisions on the circular scale with a pitch of 1 mm. When measured the diameter of a pin using this screw gauge, 49th division of the circular scale got matched with the main scale line and it was showing 1 mm on the main scale. Calculate the least count of the given screw gauge
0.01 mm
0.01 cm
0.02 mm
0.03 mm
In an automobile industry, during the inspection of a drilled hole by the inspector, the ‘Go gauge’ entered the hole. What should be preliminary decision
Accept
Reject
Can’t say at this juncture
None of the above
