Use __________ or another practical way to secure and support the work piece to a stable platform.

Accessories must be rated for at least the ___________ recommended on the tool warning label.

If cutting into existing walls or other blind areas where electrical wiring may exist is unavoidable, _______________all fuses or circuit breakers feeding this worksite.

Do not operate the ___________ shaft with a sharp bend.

Always____________the power cord from the power source before making any adjustments or attaching any accessories.

Be aware of the __________location, when placing the tool down or when picking the tool up.

Always hold the hand piece _______ in your hands during the start-up.

Always wear ____________and dust mask. Use only in well ventilated area.

After changing the bits or making any adjustments, make sure the collet nut and the EZ TWIST integrated wrench/ nose cap are both securely ______________.

Do not reach in the area of the__________bit.

Allow brushes to run at__________speed for at least one minute before using wheel. During this time no one is to stand in front or in line with the brush.

Wire and bristle brushes must never be operated at speeds greater than_____________ /min. Direct the discharge of the spinning wire brush away from you.

Wear protective gloves and face shield with wire or bristle brushes. Apply wire or bristle brushes _________to the work as only the tips of the wire/bristles do the work.

________ handle both the tool and individual grinding wheels to avoid chipping or cracking. Install a new wheel if tool is dropped while grinding. Do not use a wheel that may be damaged

Never use____________or damaged bits. Sharp bits must be handled with care.

Use clamps to support workpiece whenever practical. Never hold a small workpiece in one hand and the tool in the other hand while in use. Allow for sufficient space, at least _____ inches, between your hand and the spinning bit.

Inspect your ___________ before cutting. When cutting irregularly shaped workpieces, plan your work so it will not slip and pinch the bit and be torn from your hand.

Never start the tool when the bit is ___________ in the material.

Avoid bouncing and _________ the wheel especially when working corners, sharp edges etc.

If the workplace or bit becomes jammed or bogged down, turn the tool “____ ” by the switch. Wait for all moving parts to stop and unplug the tool, then work to free the jammed material.

Do not leave a running tool ________ , turn power off.

Do not grind or sand near _______ materials.

Do not _______ the bit or collet after use.

Regularly clean the tool’s air vents by _________ air.

Do not __________or misuse tool.

This product is intended for use as a dental drill, in human or veterinary medical applications.

When using the steel saws, cutoff wheels, high speed cutters or tungsten carbide cutters, always have the work securely clamped. Never attempt to hold the work with one hand while using any of these accessories.

What part is letter A?

What part is letter B?

What part is letter C?

What part is letter D?

What part is letter E?

What part is letter F?

What part is letter G?

What part is letter H?

What part is letter I?

What part is letter K?

What part is letter J?