NEW
Font size
Worksheetsfloor jacks and jack stands
Total questions: 15
Worksheet time: 8mins
when jacking a rear wheel drive vehicle from the back, where would you place the jack?
gas tank
floor pan
the pumpkin
the bumpers
When lifting a rear wheel drive vehicle, where would you place the jack stands?
On the lifting points
On any of the plastic parts
Under the pumpkin
Under the tires
when jacking the front of the car, where would you place the jack?
oil pan
radiator support
cross member
exhaust
when jacking a vehicle would you chock ..
one wheel
two wheels
no wheels
all the wheels
what are jack stands used for?
To make the car look cool
To support the vehicle
Just because
To raise the vehicle
are people allowed in the car while raising it?
yes
no
when you are lowering the car...
Go fast to save time
Go slow to prevent damage
Don't ever lower a car!
Be sure the jack is locked
do you chock the vehicles wheels?
yes
no
where would you place the chocks when jacking the vehicle from the front?
In front of the front wheels
Behind the back wheels
On all four wheels
Under the lifting points
where would you place the chocks when jacking the vehicle from the back?
Behind the back wheels
In front of the front wheels
On all four wheels
Under the lifting points
before lifting a vehicle, what should you check about the ground surface?
That it is sloped
That it is wet
That it is soft
That it is level and solid
what is the primary reason for using wheel chocks when jacking a vehicle?
To lift the vehicle higher
To support the jack
To mark the parking spot
To prevent the vehicle from rolling
after raising a vehicle with a jack, what should you do before working underneath?
Remove the jack
Place jack stands under the vehicle
Start the engine
Release the parking brake
What is the most important thing to remember when raising the vehicle with a floor jack?
Work quickly and don't waste time
Be sure the jack will not damage anything it is touching
Always make sure that the jack handle is kept in a horizontal position
Keep your body completely under the vehicle frame
What is the best way to control how fast the car comes down when you lower the floor jack?
Turn the handle quickly
Use the "indian-burn" technique
Use the jack stands to break the fall of the vehicle
Tap the floor jack gently with a rubber mallet
