Worksheets4A06 Admin Quiz for Milestone Demos
Total questions: 10
Worksheet time: 7mins
Which mathematical expression is formatted correctly?
Acos(B) = 9 units
Acos(B) = 9 units
Acos(B) = 9 units
Acos(B) = 9 units
Which of the following is NOT necessarily an example of mathematical modelling for engineering design?
Verifying in MultiSIM that your voltage regulator design works as intended before purchasing parts.
Using the structural analysis tool in AutoDesk to determine the best placement of support beams on your design.
Calculating the expected lifetime of your LiPo battery based on the power draw of your components.
Calculating the force required to overcome the drag experienced by a body moving in water.
Which of the following statements about the Performance section is true?
The maximum achievable grade on Performance is equal to the achieved grade on Mathematical Modelling.
Performance is evaluated by comparing your documented performance against your target specifications.
It is possible to achieve a perfect grade on Testing if your Performance grade is not perfect.
All of the above.
True or False: Grammar and formatting errors only result in deductions from the Presentation and Formatting grade.
True
False
Which of the following are NOT required in the report for a perfect grade on Operating Instructions?
Circuit diagrams and engineering drawings for any non-trivial component you have designed.
Additional required equipment needed to operate your device (i.e. computer, OS, etc.).
A non-zero grade on Performance.
Boot-up and shut-down procedures for operation of your device.
The Milestone Reports are intended to build up to the Final Report submitted at the end of the year. Which of the following statements is true?
A Module Report with a grade of 140/140 would receive a grade of 140/150 if submitted at Integration.
The Mathematical Modelling section does not necessarily undergo substantial changes over the course.
Mistakes on prior reports left uncorrected result in the same deductions in subsequent reports.
All of the above.
Which of the following legitimate sources is NOT an appropriate resource for discussion of EHS codes?
The Electricity Act.
The Environmental Protection Act.
The Highway Traffic Act.
None of the above.
Which of the following statements best describes the Assembly Instructions?
Includes the steps required to build any non-trivial component that has been designed.
A detailed description of the parts that were purchased/designed, and how they are successfully integrated.
All of the steps between the purchase of materials and operation of the device.
None of the above.
Which of the following statements is NOT true about the SDS Précis?
Common project materials, such as solder or adhesives, do not have to be accounted for.
This section acts as a summary of potentially harmful materials used in the project.
Actual SDS should be included somewhere in the reports.
Materials listed in this section should also be written up as safety reports submitted to the TAs.
Which of the following is NOT a way of employing good scientific measurement for your Testing section?
Identifying sources of error within your test setup.
Recording uncertainties in your measurements.
Attempting to reproduce your results.
Ensuring your project can be operated by somebody unfamiliar with its nature.
