NEW
Font size
Worksheets204.1
Total questions: 24
Worksheet time: 15mins
When using a surface planer, a dip in the trailing end of timber known as snipe is caused by ?
Infeed table too low relative to the blades
Outfeed table to high relative to the blades
Outfeed table too low relative to the blades
Side fence not set square
When planning short lengths of timber the operator should use ?
Gloves
A pushtick
A pushblock
A slow feed speed
When machining Mortise and Tenon joints which should be cut first ?
The Tenon
The Mortice
When changing the blades in a planning machine the best way to set the height of the blades so that they are all the same height is to ?
Set them by eye
Set them by measuring with a steel rule
Use setting gauges designed for the machine
TCT stands for ?
Tungsten Carbide Tipped
Tough Carbon Tooling
HSS stands for
Hardened Steel Saw
High Speed Steel
Under PUWER regulations when a machine is turned off its braking devices must ensure the blades stop after ?
3 seconds
10 seconds
30 seconds
What safety device stops timber closing in or binding on the saw blade as it is cut ?
A Crown Guard
A Riving Knife
A major hazard when machining timber is ?
Loose knots flying off
Hard timber
Woodworm holes
When machine thicknessing timber the face side and edge should be placed ?
Facing up
Facing down on the machine bed
This tool is used to _________________ wood or metal.
Scrape
decorate
paint
measure
This is a pry bar.
true
maybe true
definitely true
not true at all
What type of square am I called?
Combination
Level
small
framing
Can you guess what I am?
Extra teeth for a robot
curry comb
paper weight
band saw blade
Name the tool shown.
Coping Saw
Hand Saw
Tenon Saw
Ridged Saw
What does the acronym PVA stand for?
Polyvinyl Acetate
Polyvinyl Acetone
Primer Veneer Adhesive
Position Verifying Adhesive
