WorksheetsL1 unit103 test revision
Total questions: 15
Worksheet time: 8mins
what hazard is most common when lifting blocks
vibration
hazardous substances
manual handling
dust
what hazard is most common when mixing mortar
noise
vibration
moving vehicles
chemical splashes
what hazard is most common when cutting blocks by hand
vibration
noise
smoke
flying materials
what is gauge for 4 course of bricks
450
150
225
300
which one of the following does a specification show
size of rooms
height of ceilings
position of external windows
type of materials used
which scale would commonly be used for a plan drawing of a two storey house
1:2500
1:50
1:10
1:1
which one of the following will give the dimensions for building a block wall
working drawing
specification
building regulations
manufacturers instructions
which one of the following will identify hazards
specification
working drawings
risk assessment
building regulations
which type of block is most commonly used for load bearing walls
lightweight aerated blocks
decorative glass blocks
dense concrete blocks
lightweight foundation blocks
which tool should be used to dress cut blocks
claw hammer
cold chisel
plugging chisl
scutch hammer
what should be used to hold a line at an internal corner
a spade
brick hammer
steel pins
masonry drill
which one of the following should be used to provide a half round tooled finish
jointing iron
tingle plate
pointing trowl
brick trowl
which one of the following should be used to check the face plain of blockwork
boat level
plumb level
straight edge
lines and pins
the height of new blockwork is limited to reduce
hand injuries
excessive waste
wall collapse
excessive cutting
which one of the following must be worn when cutting a block
ear defenders
helmet
dust mask
eye protection
