WorksheetsModule 7 - Quiz 2
Total questions: 25
Worksheet time: 29mins
When a tolerance has both high and low limit, it is called
Unilateral tolerance
Bilateral tolerance
Multilateral tolerance
In an assembly, when the shaft is always smaller than the hole, it is called
Clearance fit
Interference fit
Transition fit
Rubber components should be stored in
warm and humid condition
well lit room
a cool and dark area
The hack saw blade is installed to the frame in a way that
the cutting edge is facing towards the handle
the cutting edge is facing away from the handle
force is applied in both direction during sawing procedure
Fine hacksaw blade has how many teeth per inch?
14 to 18
24 to 32
18 to 24
Drill angle used in aircraft sheet metal repair is
59 degrees
118 degrees
125 degrees
What tool is this?
Straight peen hammer
Cross peen hammer
Ball peen hammer
What is the purpose of the ratchet on the thimble?
prevent wear on the anvil
prevent movement of the thimble
prevent over-thightening of the thimble
Spanner size which is one size bigger than three-quarter is
13/16
11/16
15/16
What tool can be used to smooth a countersunk rivet head that protrudes from a surface?
Rivet head smoother
Micro miller
Rivet head cutter
The scale on the thimble of a micrometer represent
0.01 inch
0.0001 inch
0.001 inch
The most common unit for a torque wrench is
pound per square inch
inch pound
newton inch
What is the actual amount of torque applied to a fastener when a 10 inch torque wrench use a 2 inch extension and has been set to 100 inch pound? (Don't worry I give you 5 minutes time to find the formula and answer)
10 feet pound
140 inch pound
150 inch pound
The approved engineering drawing standard used in aviation industry is
BS 307
BS 308
BS 309
A schematic drawing of a hydraulic system indicates
the type and quantity of the hydraulic fluid
the specific location of the individual components within the aircraft
the direction of fluid flow through the system
Zone 600 of an aircraft is
right engine
right wing
landing gear
If a dimension is given as 3.638 inches +0.004 -0.002, which statement is true?
The minimum acceptable dimension is 3.634 inches
The maximum acceptable dimension is 3.6344 inches
The minimum acceptable dimension is 3.636 inches
This is a symbol for
First angle projection
Second angle projection
Third angle projection
Hydraulic power system in aircraft is discussed in manuals in ATA Chapter
32
29
57
ATA Chapter 27 is
Flight controls
Fuselage
Fuel system
IPC stands for
Illustrated Parts Catalogue
Illustrated Parts Components
Indicated Power Circuit
Three point Trammel is a tool used to detect
round-out
bow
wear
The difference in dimension between two mating parts is called
tolerance
allowance
deviation
Which of the answer below is a good example on the usage of dial test indicator?
To perform a run-out check on a shaft
To carry out bow check
To measure inside diameter of a tube
Listed below are some of Admal Aviation College lecturers. Who is your favourite among these lecturers?
