Font size
WorksheetsTrident Racing Recruitment Test
Total questions: 26
Worksheet time: 22mins
Which of these is not a parameter related to steering geometry?
Caster angle
Heel angle
Toe angle
Camber angle
Which of these brake type would you prefer for our new vehicle?
Air brake
Drum brake
Disc brake
Hand brake
3) A car consists of these power sources:
Fuel and engine
Fuel and inertia
Storage battery and fuel
Alternator and fossil fuel
Find the Odd Man Out
Spark plug
Master cylinder
Fuel injector
Drive shaft
5) What is the unit of normal force?
Newton (N)
Newton meter (Nm)
Watts (W)
Joules(J)
6) Throttle is a component related to ...
Engine
Suspensions
Brakes
Aerodynamics
Which of these is the lightest material?
Cast Iron
Aluminium
Steel
Stainless Steel
Which of these is not considered for designing any component?
Shear stress
Hardness
Shear Strain
Colour
Which of these will be used for chassis structure?
Sheet Metal
Pipes
C-columns
Plates
What is used as fuel in our vehicle?
Diesel
Gasoline
Ethanol
Electricity
Which of these is not a type of welding?
Arc welding
MIG welding
Gas welding
Neon welding
The major pollutants emitted from the exhaust due to incomplete combustion are:
Carbon Monoxide
Hydrocarbons
Oxides of Nitrogen
All of the above
Only Carbon Monoxide and Hydrocarbons
What is the minimum value of ground clearance for Formula Bharat (in mm)?
10
20
30
No such condition is mentioned.
What is minimum value of jounce for Formula Bharat (in mm)?
20
25
30
40
How many types of tires are required for Formula Bharat? Choose multiple answers.
Wet
Dry
Radial
Bias
What is minimum wheelbase required?
1565
1525
1656
1425
What type of driver restraining system is allowable in Formula Bharat?
6 point
7 point
4 point
5 point
What is the value of force against which brake pedal must withstand without failure?
4 kN
1000 N
900 N
2kN
What is minimum length of single line of LED’s used for brake light (in mm)?
50
55
80
150
Hydraulic brakes’ function is based on the principle of
Law of conservation of momentum
Pascal’s law
Bernoulli’s principle
None of the above
The process of removing air from the brake system is known as
Bleeding
Self energizing
Servo action
None of the above
Compression ratio in an IC engine is
The ratio of maximum to minimum volume in cylinder
The ratio of minimum to maximum volume in cylinder
Ratio of pressure after compression and before compression
None of the above
Which type of joints are used when the shafts are inclined
Universal Joint
Ball and Socket Joint
Hinge Joint
Pivot Joint
________ provides all the torque to the wheel with low traction.
Open Differential
Limited Slip Differential
Locked Differential
All of the above
Master cylinder comes under __________ department.
Steering
Chassis
Braking
Powertrain
Which department would you reduce the funding to if there was a financial crisis ? Explain in as many words as possible.
