Font size
WorksheetsCTE Miter Saw
Total questions: 26
Worksheet time: 20mins
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Release it to the up position.
Hold it in the down position.
Raise 1" above the stock being cut.
Pull to the out position.
What special protection must be observed when using the motorized miter saw outside?
Keep the saw covered.
Lubricate the saw more often than normal
Unplug the saw after each cut
Connect the saw to a ground fault circuit interrupter (GFCI).
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
Hold the saw firmly
Push the saw through the material slowly
Hold the saw down securely after the cut is made
When is it safe to remove wood scraps from the cutting zone on the motorized miter saw?
While the saw is positioned over material and ready for a cut to be made
While the saw blade is clamped in the down position
While the saw is off and the hand is not on the Off/On switch
While the blade is up.
Where should the saw blade be positioned when cutting is completed and the operator is leaving the work zone?
Up
Down
In its safest position
Either Up or Down
Hands or fingers never come closer than __________ to the rotating blade when operating the motorized miter saw
2 inches
4 inches
6 inches
8 inches
What personal protection equipment should be worn by a motorized miter saw operator?
Hearing protection, eye protection and a dust mask
Eye protection
Eye protection and hearing protection
Hearing and eye protection, dust mask and gloves
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ____________ .
see if the material is positioned correctly
see if the saw is cutting properly and is set accurately
see how the material will cut
test the sharpness of the saw blade
Where should the saw blade be aligned when making a cut with the motorized miter saw?
Left side of the marking line
Right side of the marking line
Waste side of the marking line
On the marking line
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw that has a sliding arm
Pull out, push down, then push forward
Pull out then push down
Push down
Push down, then pull out
The purpose of a "stop" when making multiple cuts with the motorized miter saw is to ____________
hold the stock securely
improve cut accuracy and reduce time required to make cuts
reduce time required to make cuts
get hands and fingers further away from the cutting zone
If a kickback should occur when a cut is being made the saw operator should ____________
jump out of the way
turn loose of the saw immediately
raise the saw to the up position immediately
hold the saw firmly in the down position and release the On/Off switch
What number is the Fence
(a)
What number is the Table
(a)
What number is the Miter Adjusting Lever
(a)
What number is the Miter Scale
(a)
What number is the Turn Base
(a)
What number is the Vertical Holddown Vice
(a)
What number is the Arm
(a)
What number is the Slide
(a)
What number is the Stationary Blade Guard
(a)
What number is the Safety Start Button
(a)
What number is the on/off switch
(a)
What number is the Handle
(a)
What number is the Blade
(a)
What number is the Retractable Blade Guard
(a)
