Font size
WorksheetsCTE Router Test
Total questions: 24
Worksheet time: 17mins
The part used to hold in the bits in a portable router is the ________
Collet
Jacobs Chuck
4 Jaw Chuck
Pilot
When starting a cut with the router, the bit should be______
Not be in contact with the stock
Be in place and ready to start cutting immediately
Slightly tilted to make starting easier
Elevated to make it easier to see
Feeding the router to fast will result in ________
Fine cuts
Excessive wear
Burning the wood
Splintering
Which is not a safety precaution for the router?
Wear safety glasses
Hold the router with both hands
Use a bit with a pilot end
Disconnect power before changing the bits
When changing cutters, one should insert the shank of the bit ______ inch into the chuck
1/8
1/4
3/4
1/2
Cutting with the router is more efficient if the router is moved _______
Clockwise
Counter clockwise
Left to right
Right to left
Which of the following should be observed when using a router ________
Do not stand in wet or damp places
Wear a dust mask
Wear safety glasses
All are correct
The depth of the cut on the router is made by turning the ______
Collet Adjustment
Micro Meter Depth Adjustment
Guild Adjustment
Frame Adjustment
After the cut is complete, one should ________
Lift the router from their work
Disconnect the router
Shut off the motor
Wait till the bit stops rotating before you continue with anything else
To prevent splintering at the corners, one should cut the _____________ first
End grain
Middle section
Left side
Right side
When cutting with the router the power cord should be located_______
In front of the router base
From the left of the stock
From the right of the stock
Away from the line of work
Before making a cut with the router, what check should be made _____________
Make sure the circuit breaker is off
Make sure the switch is off before unplugging the router
Make sure the router will be overloaded
Make sure your wearing shoes
A major safety precaution to observe when changing router bits is _________
Keep the bit clean and sharp
Keep the depth of the cutt to a minimum
Unplug the router before changing the bit
Loosen the micro meter adjustment so you can reach the bit.
When operating a router, it would not be safe to wear ________
A ring
A bracelet
Loose clothing
All of these should not be worn
The correct procedure for holding a router while making a cut is ________
Hold it on the stock with pressure on the cutter bit side
Hold firmly with both hands
Hold the handle with one hand and guide the router with the other hand
Hold one hand on the handle and the other hand on the motor housing
What number is the Cord Strain Reliever
(a)
What number is the Guide Knob
(a)
What number is the Base
(a)
What number is the Micro Meter Depth Adjustment
(a)
What number is the Collet Chuck
(a)
What number is the D Handle
(a)
What number is the Locking Handle
(a)
What number is the Motor Disconnect
(a)
What number is the Trigger Switch
(a)
