WorksheetsSafety Review
Total questions: 32
Worksheet time: 32mins
A ____ is used to raise a vehicle in the air.
Creeper
Lift
Jack Stand
All of the Above
When draining fuel from a vehicle, which of the following guidelines should be followed?
Drain fuel in well-ventilated area
Only drain fuel in a level space
Disconnect the vehicle’s battery
All of the answers listed
Class ______ fires involve combustible metals such as sodium, titanium, and magnesium.
A
B
C
D
Class C fires involve:
Electrical Equipment
Paper and Wood
Flammable Liquids
None of the Above
Technician A says a type A fire may be extinguished with an ABC type fire extinguisher. Technician B says that a type B fire must be extinguished with a type A fire extinguisher. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
When lifting a vehicle with a floor jack, which of the following actions should take place before working on the vehicle?
Check for heavy loads in the vehicle that may be heavier than the working load of your jack
Place jack stands in the appropriate support points
Chock at least 1 wheel and set the parking brake
All of the above
When working on a vehicle’s steering and suspension system, what lifting mechanism is to be used?
4 Post Alignment Rack
2 Post Lift
Floor Jack
Scissor Lift
Who do you trust for instructions on how to use a piece of equipment?
Your “experienced” classmate
YouTube
Mr. Lear
All of the above
What causes an electrical fire in an automobile?
When the radio is too loud.
When a hot wire touches a ground on the vehicle.
When the temperature gauge on the dash reaches the red.
When the vehicle has too much gasoline.
What is the MOST dangerous and underestimated flammable substance in the shop?
Hot oil
Brake fluid
Kerosene
Gasoline
What color wire in the steering column will trigger the airbag if cut?
Green
Red
Yellow
Orange
What color wire on a hybrid vehicle should be avoided without the proper tools and equipment?
Green
Red
Yellow
Orange
Technician A says that safety glasses must be worn in the shop only when performing vehicle repairs from underneath. Technician B says that safety glasses are optional. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
Where are the fire extinguishers located?
At the center of each wall in the classroom
At the center of each wall in the shop
In Mr. Lear’s office
All of the above
How many fire extinguishers are in the shop?
1
2
3
4
Where in the first aid kit located?
On the bookshelf in the classroom next to the shop door
At the center of each wall in the shop
In Mr. Lear’s office
All of the above
When operating a lift which of the following actions must be taken?
Check for people as well as equipment such as safety stands, oil catch pans, and tools are clear when lowering a vehicle
Call out “CLEAR” when raising or lowering a vehicle
On a 2 post lift, position the lift arms on the manufacturer's specified lift points.
All of the Above
Technician A says that the most common injury in the automotive shop is death. Technician B says that the most common injuries in an automotive shop are physical injuries such as scrapes, strains, pulled muscles, or mild burns. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
Technician A says if you can’t turn a bolt with a small or short handled wrench, you should give up. Technician B says if you can’t turn a bolt with a small or short handled wrench, you should get a wrench with a longer handle for more leverage. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
Technician A says it is NEVER okay to wear jewelry, neckties, and loose clothing when working on a vehicle. Technician B says jewelry, neckties, and loose clothing are okay to wear as long as you are ONLY using hand tools such as wrenches or pliers to work on a vehicle. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
Technician A says it is okay to eat in the shop as long as you are not working on a vehicle. Technician B says that it is never okay to eat in the shop. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
The acronym for fire extinguisher use is PASS, which stands for Pull, Aim, __________, and Sweep.
Squeeze
Step
Squat
Secure
Technician A says to refer to Google for all information about handling potentially hazardous materials. Technician B says to refer to the MSDS for information about handling potentially hazardous materials. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
When moving a vehicle in the shop, which of the following describes the correct procedure?
Roll at least one window down and turn the radio off
Be aware of your surroundings using mirrors, backup cameras, and direct eye contact
Never stand in front of a vehicle when guiding someone on the lift
All of the above
Technician A says that tools should be wiped off after each use. Technician B says that grease should be left on tools because it shows that you have been working. Who is correct?
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A or Technician B
The area meant for learning from books, videos, and slideshows is called the _________.
Toolroom
Office
Repair Area
Classroom
The area meant for storage of tools and small equipment is called the ________.
Toolroom
Office
Repair Area
Classroom
The area meant for working on vehicles for a hands-on learning experience is called the ________.
Toolroom
Office
Repair Area
Classroom
Students are not allowed in Mr. Lear’s _____ without permission.
Toolroom
Office
Repair Area
Classroom
Where are used shop rags stored?
Trash can
On the Shop Floor
Dirty Rag Bin
All of the Above
What grade must you make on your safety test to be able to work in the shop?
99%
100%
75%
60%
Who is responsible for your safety in the shop?
Your Classmate
Mr. Lear
Carl Loftin Career and Technology Center
Yourself
