Font size
WorksheetsCCNA Modules Review Quiz #4
Total questions: 22
Worksheet time: 11mins
What is the specification for a cable that is 100 MB baseband made of copper twisted pairs?
100BASE-CT
100BASE-TP
100BASE-TX
100BASE-CX
What is the specification for a cable is single mode fiber running up to 10 Km?
CT
CX
TP
LX
What is the specification for a cable that is multi-mode fiber running up to 2000 meters?
TX
SX
FX
LX
What command will show the detailed statistics on a Fa 0/24 of Switch 1, including errors?
Switch 1 #show switchport
Switch 1 #show ip interface brief
Switch 1 #show interfaces
Switch 1 #show run | begin Fastethernet 0/24
Devices that are on the same network segment are also on the same _____________.
broadcast domain
network domain
collision domain
ethernet domain
The distance limitation for a single run of Cat5e ethernet cable is ________.
1000 feet
100 feet
1000 meters
100 meters
Which of the below standards are designed for use with fiber optic media?
100BASE-TX
1000BASE-TX
100BASE-LX
1000BASE-CX
Which of the following uses fiber media? (choose all that apply)
TX
LX
FX
SX
What are the default speed and duplex settings on a fastethernet interface of a Cisco switch?
100 / full
100 / half
10 / half
auto / auto
How would you view the layer 2 addresses that have been dynamically learned by a switch?
show mac-address-table
arp-a
show arp
show interfaces
What is the default spanning-tree priority on a Cisco switch?
65535
32768
61440
4096
The maximum configurable value with PVST+ is _________.
65535
8729
61440
4096
RSTP (Rapid Spanning Tree Protocol) is based on which IEEE protocol specification?
802.1W
802.1D
802.1X
802.1R
STP (Spanning Tree Protocol) is based on which IEEE protocol specification?
802.3
802.1D
802.1X
802.11
What does an ethernet switch do when it receives a broadcast frame?
decrements (TTL) field by 1 and forwards to the next hop
floods out all ports in the same VLAN as the source
floods out all ports on the switch
verifies the destination address in the mac-address-table
You have several switches connected using trunk links and all are set to the default STP priority of 32768. Which switch will become the root bridge?
The switch with the numerically highest mac address
The switch with the numerically highest ip address
The switch with the numerically lowest mac address
The switch with the numerically lowest ip address
True or False: A new switch with a STP priority that's lower than the current root bridge is added to the network. The new switch becomes secondary root bridge and is elected as root bridge if the first root bridge fails.
True
False
True or False: If a switch with a lower bridge ID is connected to a network, then it will immediately take over as the root bridge because it has the highest BPDU.
True
False
True or False: By default, STP would prefer a path with 4 Gigabit links than a path with 1 FastEthernet link.
True
False
The switch with the _______becomes the root bridge.
highest bridge ID
highest mac address
lowest bridge ID
lowest mac address
Which address does a switch learn and store in its mac address?
destination mac address
source mac address
destination ip address
source ip address
When life gets rough, you think about...
family
pets
sleep
running to Jacob for help D:
