NEW
Font size
WorksheetsSTEERING AND SUSPENSION
Total questions: 13
Worksheet time: 10mins
When lubricating the front suspension,
The grease zerks (fittings) should be wiped clean before greasing
Any type of grease may be used
The ball joint should be greased until the grease comes out of the joint
The engine should be running
If a front wheel has radial movement, but the ball joints check good, what would be the most likely cause?
A worn idler arm
A bad tie rod end
Loose wheel bearings
Bad pitman arm
Camber is the
forward and backward tilt of the steering axis
inward or outward tilt of the wheel at the top
inward or outward tilt of the wheel in the front
none of the above
As part of a pre-alignment inspection, the technician should check
tire pressure
riding height
ball joints
all of the above
The number 205 in the (P205/75R15) tireinformation indicates the tire
section width
section height
pressure
load rating
The modified MacPherson strut rear suspension is very common in
Front-wheel drive cars
Rear-wheel drive cars
Pickup trucks
Station wagons
Extreme tire wear on the inside edge of the tire tread indicates excessive
positive caster
negative caster
positive camber
negative camber
Excessive positive camber will cause tire wear around
both inner and outer edges
the center
the inner edge
the outer edge
