The __________ separates the rollers in an antifriction bearing and allows them to turn freely. Pg 127

_____________ is a method of temperature mounting that is used to install a bearing into a housing. Pg 160

In a bearing press kit, the lip helps to align the _________ to the cup during the tightening process. Pg 148

Two methods used to pack a bearing with grease are using a bearing packer and ________

The cup follower method of retaining a tapered roller bearing presses against the ___________ of the bearing.

A bearing should not be heated to a temperature exceeding __________ unless specified by the bearing manufacturer.

When using the hammer and driver method to remove a roller bearing, the _________ race must be supported. Pg 149

A(n) ___________ is used with a push-puller to remove bearings. Pg 155

The _________ method of mounting tapered roller bearings places the backs of the bearing cups together. PG 174

___________ mounting of bearing is used to expand or contract the bearing races

A bearing press kit includes a _______ which provides space for the bearing to come out of the housing during removal. Pg 151

The bore of a replacement bearing must be measured to make sure that it will fit _________ Pg 136

The slide-hammer is a(n) __________ method that uses an upward hammering motion to remove a bearing cup from a housing. Pg 154

The three widths used to specify a tapered roller bearing are: overall width, cone width, and _________ width. Pg 135

The ________________ locknut requires a groove to be cut into the shaft.

A tapered roller bearing must be adjusted because ________. Pg 165

Using _________ to install a bearing on a shaft results in even pressure being applied to the bearing race.

______________ roller bearings are the highest speed roller bearings. Pg 128

Four types of roller bearings are cylindrical, _____________, tapered and needle

__________________- bearings do not have an inner race.

The inner race of a roller bearing fits on a shaft, on a tapered roller bearing, it is called a(n) ____________

The outer diameter measurement of a tapered roller bearing is taken from measuring the outer race or _________________.

When specifying a tapered roller bearing, you need the cone width, cup width, and _____________ width

____________________ mounting of a bearing can be used to expand or contract the size of a bearings races.

When mounting a bearing to a shaft using the hammer and sleeve method, the sleeve must rest only on the _______________ race

A(n) ______________ ______________ is used with an external bearing puller to remove a bearing.

The advantage of using an arbor press over a hammer is that pressure is ______________ distributed.

The three types of bearing pullers are external bearing puller, _____________ ____________, and internal bearing puller.

When driving a roller bearing off with a hammer, use a mandrill made of a(n) ___________ metal than the shaft.

A heat range of 200 F to __________ F is sufficient to expand a bearing for installation.

A(n) ____________ us used to control the inner race of a bearing.

_______________ heaters are designed specifically to heat bearing for installtion.

Hand packing is used to pack a bearing with ___________ without using any specialized tools.

__________________ a bearing means to control the tightness or play between the cup and cone of a bearing.

Three methods of retaining a tapered roller bearing are locknut, _______ ________, and cup follower.

The ___________ ____________ method of retaining a tapered roller bearing uses a sleeve that presses against the cup of the bearing.

____________ mounting of tapered roller bearings means the bearings are located back to back.

End play will ____________ due to hear in a direct mounted bearing configuration.