Heavy objects should be lifted by two people.

To avoid splinters and other minor injuries you should always wear gloves when handling wood.

Long objects should be lifted by two people; one at each end.

Before cutting used lumber, remove all nails and other foreign materials from it.

A portable power drill is designed to be used with one hand.

Dull cutting tools can cause more injuries than sharp tools.

A correct screwdriver fit will prevent slipping and lessen the chance of injury.

When working with wood, you should always secure your work to allow the use of both hands on the tool.

Sharp edged tools should be stored so that the cutting edges will not be damaged.

Good leather shoes are optional when working in the shop..

Use a rip saw to cut across the grain of a board.

When in doubt, ask the instructor or an advanced student for assistance.

When deciding which tool to use for a particular job, the size of the tool should be an important consideration.

When using any woodworking tool, be aware of your position so that no one around you might be injured from flying tools, wood or other objects.

Keep tools clean and store them properly.

Auger bits should be used with a bit brace.

Broken or damaged tools should be marked “unsafe” and repaired before using them.

If you can’t find a ball peen hammer it is okay to use a claw hammer to strike a punch.

Safety should always be a priority when working in the shop.

Once you have been instructed in the use of power tools, you do not need the instructor’s permission to use them.

Gloves are bulky and considered a hazard when using power tools.

Eye protection is required when using power tools.

It is unsafe to use a tool before it reaches full speed.

Minor cracks or chips in a saw blade are no big deal.

As you gain experience with power tools, you can take short cuts like using a scrap piece of wood to slow the blade down.

Whenever adjustments or repairs are performed on a power tool, make sure it is unplugged or the power turned off.

Proper tool storage will give the tool longer life and safer operation.

On the table saw, the blade height should be no more than 1/2” above the wood being cut.

Stand directly in line with the saw blade so you can see better when cutting.

Stay with the saw until the blade comes to a complete stop.

A 4” margin of safety between your fingers and the blade is required when using the table saw.

Make sure all guards are in place when using power tools.

Avoid positions where you can slip and fall on the blade of a saw.

If a tool has a damaged electrical cord, tape it up before you use it.

Never cut long stock by yourself.

On the table saw, be extra careful and use the rip fence and the miter gauge together when cutting wood.

When cutting material with the compound miter saw use a push stick for short pieces.

You can reach over the saw blade to remove wood only if your shoes have non-slip soles.

Keep the work area clean.