From the deaerator, oxygen and other noncondensable gases are separated from the feedwater and directed toward the atmosphere ___

A(n) ___ system is a system of measuring instruments and controllers that work together to control a process

One pound of water is needed to produce ___ of steam

In a low pressure gas system, the ___ valve is an electric valve that cannot be opened until the gas pilot is lit

___ are used for loads that require dry steam, such as turbines

In a feedwater system, the ___ valve is located closest to the shell of the boiler on the feedwater line so that the check valve can be repaired without draining (dumping) the boiler

A steaming boiler can have the water from the gauge glass go from half full to empty in a matter of ___ if water is not added to the boiler

Superheated Steam Has More ___ Than Saturated Steam at the Same Pressure

The Deaerator Tank Is Located ___

A gas pilot line on a high-pressure gas system supplies gas through a ___ valve to the pilot gas-pressure regulator

The purpose of any fuel oil system is to supply fuel oil to the burner at the proper ___

No. _ fuel oil needs to be heated before it is pumped so it can flow

Pulverizing coal allows ___

Draft is ___ caused by a difference in pressure between two points

Natural draft is a result of temperature differences between ___

In a low-pressure gas system, the air mixes with the gas in the ___

A measuring instrument can use a ___ to send a signal to a controller

Pulverized coal is ground into a fine powder and blown into the combustion chamber where it is burned in ___

A control system uses a ___ to execute control strategy

Water weighs approximately ___ lb/gal

Induced draft is produced by pulling air through the boiler furnace with a fan located in the ___

A control loop typically uses ___ as the control element

Codes may require that a(n) ___ be positioned before the firing-rate valve that controls the volume of gas to the burner

In a fuel oil system, the purpose of duplex strainers is to ___