WorksheetsM1 Module 2 Test
Total questions: 25
Worksheet time: 25mins
Masons operate in an environment that is _____.
a. protected
b. low risk
c. comfortable
d. high risk
A hidden cost of job accidents is _____.
a. insurance premiums
b. production delays
c. compensation
d. medical bills
Job-site signs that are red, black, and white are used to convey _____.
a. caution information
b. safety information
c. danger information
d. general information
A high noise level is an example of a(n) _____.
a. hazardous job condition
b. annoying but harmless problem
c. management system failure
d. normal job condition
Respiratory problems can be caused by inhaling silica, a crystal found in _____.
a. respirators
b. nitrile
c. sand
d. alkaline
Long hair should be confined in a ponytail to _____.
a. present a neat appearance
b. avoid being caught in machinery
c. keep it clean
d. make your hard hat fit properly
The minimum length of sleeves in a long-sleeved shirt should be _____.
a. 2 inches
b. 4 inches
c. 6 inches
d. 8 inches
To prevent ear infections, earplugs should be _____.
a. cleaned with nitrile
b. cleaned with a petroleum-based solvent
c. cleaned with soap and water
d. changed weekly
OSHA requires the wearing of gloves when working with _____.
a. PVC pipe
b. patching plaster
c. latex paint
d. portland cement
The method used to catch workers after they have fallen is the _____.
a. rebound system
b. personal fall arrest system
c. deceleration kit
d. spring-loaded arrest device
OSHA specifies that scaffold must be 1 foot wide for each _____.
a. 2 feet of height
b. 4 feet of height
c. 5 feet of height
d. 10 feet of height
Federal regulations prohibit gaining access to scaffold platforms by means of _____.
a. cross braces
b. stairway-type ladders
c. portable ladders
d. powered personnel lifts
To prevent falling-object injuries when working on a scaffold, only masonry and mortar should be stored
within 4 feet of a(n) _____.
a. elevator shaft
b. guardrail
c. stairway
d. building corner
Use a bucket of water to _____.
a. loosen hardened mortar on tools
b. wet brick units immediately before applying mortar
c. soak tools that will be used again soon
d. rinse mortar off scaffold platforms
15. When using a dry-cut saw, you should wear _____.
a. insulated boots
b. a full-face shield
c. a respirator
d. nitrile-coated gloves
To operate a power mixer, you must _____.
a. have a valid driver's license
b. have a valid permit
c. get permission from your supervisor
d. have proper training
The tool shown in the figure above is used to _____.
a. grind out old mortar joints
b. cut masonry units
c. trim excess mortar
d. cut reinforcement
When near a turning forklift, stand clear of the rear _____.
a. bumper
b. mast extension
c. platform
d. swing area
In a three-wire electrical cord, the color of the neutral wire is _____.
a. green
b. white
c. red
d. black
The abbreviation GFCI stands for _____.
a. grout-facing concrete installation
b. General Foundation Code International
c. ground fault circuit interrupter
d. general fault charge interrupter
When working with electrical equipment, do not wear _____.
a. canvas gloves
b. a metal hard hat
c. lenses without side shields
d. steel-toed safety shoes
To identify the strength of loads for powder-actuated tools, manufacturers use _____.
a. color coding
b. a numbering system
c. different-diameter units
d. alphanumeric codes
Bundled brick should not be stockpiled higher than _____.
a. 5 feet
b. 7 feet
c. 9 feet
d. 11 feet
Brick that has been stacked and wrapped is referred to as a _____.
a. stockpile
b. cube
c. working stack
d. unit
When stacking by reversing the direction of every other course so that the stack is secure, the stack should be
no closer to the wall than _____.
a. 4 feet
b. 3 feet
c. 2 feet
d. 1 foot
