WorksheetsMyReskill IoT Programme Day 2
Total questions: 10
Worksheet time: 5mins
1. Which USB port on the Paspberry Pi is to be connected to the Arduino?
First Port
Second Port
Third Port
Any Port
2. How much voltage is needed to power up the sensors ?
5 volt
7 volt
10 volt
13 volt
3. When should the SD Card be inserted into the Raspberry Pi?
Before Boost Up
After Boost Up
4. What does GND stands for on the Arduino ?
System Ground
Grade Non-Disclosure
Ground
Global Nearness Diagram
5. How many digital pins are there on the Arduino UNO board ?
12
14
15
16
6. The DO labeled pin on the Light Sensor is to read what kind of reading ?
Analog
Digital
7. Arduino Uno uses which USB type cable ?
USB Type A
USB Type B
USB Type C
Micro USB Type B
8. Which LED indicates data transmitting out from the board?
Test LED
FLX LED
TX LED
ON LED
9. Which of the following act as a Gateway to collect sensor data in this project ?
Arduino
Raspberry Pi
Sensor
Node-Red
10. Raspberry Pi does not support Analog Input ?
True
False
