Place the curve up face of the board face toward the cutterhead.

The depth of cut is adjusted by moving the_____table up or down.

The fence tilting handwheel is used to adjust____angles.

The maximum depth of cut for edge jointing is ____inches.

A________should always be used when operating the jointer.

The____table should only be adjusted be a qualified person when changing cutters.

When finished jointing it is your responsibility to make sure the____is stopped before leaving the machine.

The stock should be fed into the jointer so the machine is cutting____the grain.

The jointer should never be operated with the____ removed

The jointer is used to make the edge and faces of boards __________.

When jointing edges, the stock should be held flat against the____ .

To ensure the edge and face of the stock are square to each other check that the table and fence are perpendicular with each other using a____

The minimum margin of safety is____ inches when jointing a board

Your____should NEVER run directly over the cutter head