NEW
Font size
WorksheetsSRWE - Revision
Total questions: 14
Worksheet time: 7mins
What advantage does SSH offer over Telnet?
More connection lines
Connection-oriented services
Username and password authentication
Encryption
Which network device can be used to eliminate collisions on an Ethernet network?
Firewall
Router
Switch
Hub
Which type of address does a switch use to build the MAC address table?
Destination MAC Address
Source IP Address
Source MAC Address
Destination IP Address
What does the term "port density" represent for an Ethernet switch?
The memory space that is allocated to each switch port
The numbers of hosts that are connected to each switch port
The speed of each port
The number of available ports
A Cisco switch currently allows traffic tagged with VLANs 10 and 20 across trunk port Fa0/5. What is the effect of issuing a switchport trunk allowed vlan 30 command on Fa0/5?
It allows a native VLAN of 30 to be implemented on Fa0/5
It allows VLANs 1 to 30 on Fa0/5
It allows only VLAN 30 on Fa0/5
It allows VLANs 10, 20 and 30 on Fa0/5
Which distinct type of VLAN is used by an administrator to access and configure a switch?
Data VLAN
Management VLAN
Default VLAN
Native VLAN
When a Cisco switch receives untagged frames on a 802.1Q trunk port, which VLAN ID is the traffic switched to by default?
Unused VLAN ID
Native VLAN ID
Data VLAN ID
Management VLAN ID
What is an accurate description of redundancy?
Configuring a router with a complete MAC address database to ensure that all frames can be forwarded to the correct destination
Designing a network to use multiple paths between switches to ensure there is no single point of failure
Designing a network to use multiple virtual devices to ensure that all traffic uses the best path through the internetwork
Configuring a switch with proper security to ensure that all traffic forwarded through an interface is filtered
When a range of ports is being configured for EtherChannel, which mode will configure LACP on a port only if the port receives LACP packets from another device?
Auto
Desirable
Passive
Active
Which statement is true about EtherChannel technology?
STP does not run on redundant EtherChannel links
All configuration tasks must be done on the individual ports in the EtherChannel link
Links must be upgraded to support EtherChannel
EtherChannel uses existing switch ports
When EtherChannel is implemented, multiple physical interfaces are bundled into which type of logical connection?
Loopback
Port Channel
VLAN Interface
Interface Range
An EtherChannel link using LACP was formed between two switches, S1 and S2. While verifying the configuration, which mode combination could be utilized on both switches?
S1 - passive and S2 - active
S1 - passive and S2 - passive
S1 - passive and S2 - on
S1 - on and S2 - active
Which value represents the "trustworthiness" of a route and is used to determine which route to install into the routing table when there are multiple routes toward the same destination?
Routing Protocol
Metric
Administrative Distance
Outgoing Interface
What type of Ethernet cable would be used to connect one switch to another switch when neither switch supports the auto-MDIX feature?
Coaxial
Straight-through
Rollover
Crossover
