wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Environmental Technologies C

Total questions: 25

Worksheet time: 14mins

Name
Class
Date
1.

In general the installation of solar voltaic panels is known as?

a)

Prescribed developments

b)

Permitted developments

c)

Permissive developments

d)

Pre-approved developments

2.

Greywater is classified as fluid category 5 under the requirements of?

a)

Building Regulations Approved Document Part G1

b)

British Standard 6700

c)

Building Regulations Approved Document Part L1A

d)

Water supply (Water fittings) Regulations 1999

3.

Which of these is an advantage of rainwater harvesting?

a)

System is maintenance free

b)

Storage tanks are always sterile

c)

It helps decrease storm drainage load

d)

It helps increase storm drainage load

4.

Identify the 2 technologies with these disadvantages :

1. Can cause noise and visual pollution

2. Emits carbon dioxide into the atmosphere

a)

Micro-wind

b)

Solar thermal (hot water)

c)

Solar PV

d)

Biomass

e)

Rainwater harvesting

5.

The item marked A in the drawing is?

a)

Rotor

b)

Gear box

c)

Generator

d)

Tower

6.

The item marked B in the drawing is?

a)

Rotor

b)

Gear box

c)

Generator

d)

Tower

7.

The item marked C in the drawing is?

a)

Rotor

b)

Gear box

c)

Generator

d)

Tower

8.

The item marked A in the drawing shown is?

a)

DC-AC Inverter

b)

Battery

c)

Bi-directional utility meter

d)

Mains

9.

The item marked B in the drawing shown is?

a)

DC-AC Inverter

b)

Battery

c)

Bi-directional utility meter

d)

Mains

10.

The item marked C in the drawing shown is?

a)

DC-AC Inverter

b)

Battery

c)

Bi-directional utility meter

d)

Mains

11.

A drain back vessel is used on a direct solar thermal system to?

a)

Guard against overheating

b)

Protect against contamination

c)

Prevent freezing

d)

Increase system efficiency

12.

The basic operating principle of a PV system is through the?

a)

Sun’s rays heating water in pipes or cylinders

b)

Heating of solar tubes to provide heat

c)

Heat energy being used to power an electrical generator

d)

Conversion of light energy into electrical energy

13.

What is a major consideration when sizing an air source heat pump?

a)

Heat load of the building

b)

Total number of occupants in the building

c)

Orientation of the building

d)

Total hot water usage for each occupant

14.

Which of the following is important when designing a rainwater harvesting system?

a)

Roof pitch

b)

Roof area

c)

Roof shape

d)

Roof design

15.

On a solar thermal hot water heating system, the panels should be installed as close as possible to the hot water cylinder in order to?

a)

Minimise the time taken for the installation

b)

Minimise the number of soldered joints

c)

Minimise installation costs

d)

Minimise the length of pipe runs in the system

16.

A small wind turbine installed near obstacles such as trees is likely to suffer adverse effects caused by?

a)

Excessive wind speed

b)

Coriolis effect

c)

Excessive noise

d)

Turbulence

17.

In the UK, which of the following positions would be most effective for generating energy from solar photovoltaic panels?

a)

On a south facing wall

b)

On a south facing roof

c)

On a north facing wall

d)

On a north facing roof

18.

Which of the following does not normally require planning permission?

a)

Greywater re-use

b)

Micro-hydro

c)

Rainwater harvesting

d)

Micro combined heat and power

19.

Planning applications for Solar PV systems will not normally be required for systems which are less than 200mm above the roofline unless the array is?

a)

In a conservation area

b)

Roof integrated

c)

On a frame at ground level

d)

Made up from polycrystalline cells

20.

The recommended safe distance from which a ground loop should be installed from a water main is?

a)

0.75m

b)

1m

c)

1.5m

d)

2m

21.

BSEN12975: 2000 applies to which of the following renewable technology?

a)

Solar thermal

b)

Micro wind

c)

Micro CHP

d)

Micro hydro

22.

Which of the following will need to comply with Part J of the Building Regulations which relates to combustion appliances and fuel storage?

a)

Biomass

b)

Micro CHP

c)

Air source heat pump

d)

Micro wind

23.

The installation of a stand alone wind turbine will require planning permission if?

a)

There has not previously been a wind turbine installed

b)

The distance between the lowest part of the turbine blade and the ground is 6m

c)

The highest part of the turbine is 12m above the ground

d)

It is not sited on aviation safeguarded land

24.

Which of the following is a permitted development?

a)

The installation of Solar PV or Solar Thermal equipment on a listed building within the curtilage of the dwelling

b)

The installation of Solar PV or Solar Thermal equipment on a listed building which is in view of the public highway

c)

The installation of Solar PV or Solar Thermal equipment on a building which is in on land within a conservation area or World heritage site

d)

The installation, alteration or replacement of stand alone solar within the curtilage of the dwelling

25.

When using a biomass stove, it is suitable for?

a)

Heating one room and providing hot water for a house

b)

Heating and providing hot water for an entire house

c)

Providing heat for each room in an entire house

d)

Providing hot water for one room within a house