NEW
Font size
WorksheetsOnShape: Features and Part Design
Total questions: 23
Worksheet time: 12mins
You can mirror an entire feature by selecting just one of its faces in the graphics area and specifying a plane or face to mirror about.
True
False
True or False: If the part you are designing is completely symmetric, you can complete the part by designing just half of the part and using one mirror feature.
True
False
When creating a part, if the features are created in the wrong order, you must delete the features and recreate them in the correct order.
True
False
Which of the following is NOT a type of arc in Onshape?
Tangent Arc
3 Point Arc
Centerpoint Arc
Equal Radius Arc
Reference the image shown here. Based on what you learned about design intent, is there ONLY ONE unique series of commands that can be used to create this part?
Yes
No
To extrude a sketch in both directions relative to the drawing plane,you must use a Blind end type.
True
False
The only way to create the Tab feature shown in the image is to start a sketch on the top face of the rectangular base.
True
False
In the image shown, what is the best way to make all of the fillets equal in size?
Select all of the fillets and add an equal geometric constraint
Create a dimension for each fillet, using the same value for each
Add horizontal and vertical geometric constraints between the endpoints of the fillets
None of the Above
Which end type is best used when you want to extrude to a specified depth?
Blind
Symmetric
Up to Vertex
Up to Face
You must have a sketch drawn prior to activating the Extrude Remove feature.
True
False
True or False: You can select a planar face as the reference plane for mirroring a feature.
True
False
Which of the following icons represents the Onshape Mirror feature?
When using the Hole feature, it is only possible to create one hole.
True
False
Faces, edges, features, and loops can all be selected as entities to fillet.
True
False
When creating a Fillet, the Tangent Propagation option ensures that the Fillet is applied to all edges that are tangent to a selected edge.
True
False
When applying fillets, to include the edges tangent to the selected edge in the fillet, select the following option:
Circular
Conic
Tangent Propagation
Variable Fillet
True or False: You can customize the material properties of a preset material.
True
False
Mass properties are calculated based on ___________.
Steel properties
Aluminum properties
The default material used by Onshape
The material that is specified
Using the __________ option, you can change the state of a model back to where a particular feature or features weren`t yet created.
Delete
Rename
Rollback
Show
Which end type of an Extrude feature is used to add an equal amount of material to both sides of the sketch plane?
Symmetric
Through All
Blind
Up To Face
Which of the following ways allow you to place one sketch line, rather than a chain of lines?
Connect the end point of the line to an existing end point of another sketch entity
Double click when placing the line
Press and hold the left mouse button, then release
All of the Above
Which of the following is an indicator that a sketch profile is closed?
A notification will pop up saying the profile is closed
The sketch entities will turn red
A green check will appear near the sketch profile
The profile will be shaded in gray
Which type of Arc requires another entity to specify its start point?
Centerpoint Arc
Tangent Arc
3 Point Arc
None of these
