You should use a push stick or push block on the jointer when the board is

(a)  

Do not joint end grain without

(a)  

On the jointer, do not remove more than (a)   of an inch in one pass

On the jointer, the out feed table should (a)   be changed

On the surface planer, make sure the board is free of (a)  

Make sure nobody is standing (a)   the Surface Planer when a board is going through

Make sure the board is (a)   inches longer than the distance between the feed rollers. 8 inches on the small planer and 15 on the large planer.

Do not take off more than (a)   inch in one pass on the planer.

When gluing your boards together, leave them as thick as possible ( (a)   % smooth) and then surface to finished size later

Always check your board against the (a)   before turning on the Surface Planer. You can find a problem before it happens.

On the surface planer, you need to know the (a)   of the board to set it up

Make sure nobody is (a)   the planer as a board is going through

Do NOT Plane wood THINNER than (a)   on the Surface Planer. ( What is the min. Thickness?)

Do not let your hands cross directly over the cutter head when jointing what kind of boards?

(a)  

Keep your board against the (a)   to avoid kickback and keep the board jointing straight on the jointer

The minimum size LENGTH on the jointer is (a)  

The minimum size WIDTH on the jointer is (a)  

Make sure the board is at least (a)   longer than the distance between the feed rollers. 15 on the large planer and 8 on the small planer

If a board gets stuck on the surface planer, you need to turn the machine off, wait for the (a)   to completely stop before lowering the table to remove the board. Wait 2 minutes after shutting it off.

If you feed the board into the Surface Planer, and it is not touching the feed rollers, you must stop (a)   , hold down the board and turn off the machine.

Make sure no one is behind the (a)   while using the jointing

Keep your fingers (a)   away from the miter saw blade

You should lock the miter saw slide when cutting (a)   .

MS students are required to use this on the miter saw to hold the board down

(a)