Remove loose fitting clothing, jewelry, and tie back long hair.

Adjust the drill while it is running.

The tool that tightens the drill bit into the drill

The material that you are drilling is referred to as the

Long stock should be drilled with the excess to the ___ of the operator.

The piece of throw-away material that is under your stock is called

Keep hands and fingers at least 3 inches from rotating drill bits.

When drilling deep holes, drill it all at once quickly.

When you begin to break through the underneath side of the stock, ease up on the feed as to not tear the wood from the underneath side.

If a drill bit binds, turn off the drill press and carefully turn drill chuck backwards by hand to free the drill bit.

Grab the chuck with your hands to slow down the drill.

Ensure that the drill press has stopped spinning before exiting the safety zone.

Use a brush to clean up shavings.

Clean up work area when done.

Clean up work area when done.

Clean up work area when done.

Things that are available for clean-up