If you want to use just one antenna to receive multiple wireless signals from the stage, you would use a(n):

If you soft patch input 1 to channel 4, the level of the mic pre will stay with the ______:

The type of splitter that may have a ground lift to help eliminate a ground loop:

Digital trim allows you to boost or cut the signal ________________ the mic pre.

Professional digital consoles ______________ dedicated outputs for mix busses like auxes or subgroups.

If you want to use just one antenna to transmit multiple wireless signals to the stage, you would use an:

______________ consoles allow you to save and recall show files and scenes.

The type of splitter that is typically the cheapest option:

The vibration of this element inside the microphone creates an electrical signal:

Using a passive splitter without transformer isolation connects both consoles electronically, changing the impedance:

Phase is the relationship between:

A transformer isolated splitter is:

File management is the same on every digital console.

Domed antennas work well as an antenna combiner because they:

Large diaphragm dynamic mics are good for picking up which part of the frequency spectrum?

If you have two mics on the same instrument, phase can be an issue.

If you have two different instruments with separate mics, phase can be an issue.

Large diaphragm dynamic mics are typically used with which instrument?

Frequencies used for wireless transmission are ________________ than human hearing.

A transformer isolated splitter ______________ connect the input directly to both consoles.

Frequencies used for wireless transmission are typically in the ______________ range.

If you have one mic on one instrument, phase can be an issue.

Condenser mics are better for _______________ sound than dynamic mics.

The range where wireless is usually run is called:

When using a transformer isolated splitter, the console connected to the _____________ output will have to do the phantom power.

A common way to connect digital audio is with AES, which uses an XLR connector and carries _________ channel(s) through each cable.

It is OK to share a frequency with another device when using wireless.

When you raise the volume of a condenser mic onstage, the ambient stage sounds are also picked up.

When phase is an issue, you can try:

The term frequency refers to how fast or slow a wave cycles. This term is applied to:

If you have two different instruments with separate mics, phase can be an issue.

Phase can be an issue with:

Condenser mics, ________________ dynamic mics, require phantom power.

Polarity can be flipped by:

The phantom power button can be indicated on the channel strip by:

In order to avoid a loud pop when turning phantom power on or off for a condenser mic, remember to first:

Interference, which sounds like bursts of static, means you are on a ___________ frequency.

Many consoles will use Ethernet cables to make digital connections; the recommended type to use is:

A digital console system with an optical loop connects the console surface, local rack, and the stage rack, making a _________________ system.

Typically, mics used for hi hat and overhead cymbals are:

Ribbon mics are:

A professional wireless system can scan for available frequencies; when you find one, use it for the:

When setting up multiple wireless units, the typical order would be:

The direction in which microphones pick up sound is called the _____________ ________________.

This type of mic picks up sound from the front, some from the sides, and cuts the sound from behind.

This type of mic picks up sound from in front, cuts the sound from the sides, and picks up a little bit of sound from behind.

What cable is used to connect to an Antenna?

This digital audio protocol can carry up to 64 channels at 96k:

Analog snakes use ________________ cabling. (check all that apply)

The stage rack is usually placed ___________ the stage.

The stage rack handles:

Hypercardioid pattern is very similar to which other type?

The microphone typically best for presenters but not for live sound is:

The mic with a polar pattern that picks up sound from front and back equally but not the sides is:

A bidirectional polar pattern is part of the design of which type of mic?

The frequency response measures the ________________ between the input and output of an audio device.

For an EQ that isn’t boosting or cutting, the frequency response should be:

The stage rack connects the inputs on stage to the console control surface with a digital snake.

The drive lines connects the console __________________ to the speaker system.

For many FOH applications, it is common to need these drive lines:

All microphones have a similar frequency response.

A microphone that sounds open and airy probably has a _____________ frequency bump in the frequency response.

A large diaphragm dynamic mic, which helps us get some extra punch on kick drums and bass guitars, will usually have a ________________ frequency bump.

When someone sings very close to the diaphragm of a microphone, their voice will sound more pronounced in the _____________ than if they were further away.