Remove cover

Check lifeline is present and attached to the fuselage

Placard is present and legible

Pull on the coord to check it is safe to use

Make sure snaphook is present and attached to rope

LED flashes every 2-10. seconds

Placards must be present and legible

Securely mounted

Ensure tamper shield is intact

Ensure plastic cover is on and secure

Sealed with Zipper in closed position

Gloves are present and attached

Pull safety pin

Placard is present and legible

Place ceiling and sidewall lights to BRIGHT for a minimum of 15 minutes to charge

Inspect photoluminescent tracks and components for any damage or significant staining, report to PIC if any discrepancies

Place ceiling and sidewall lights to DIM for a minimum of 15 seconds to charge

Walk the cabin

1. Cylinders are securely mounted in brackets. 2. Pressure indicates a min of 1600psi. 3. Tamper evident seal is intact.

4. There must be 5 in sealed in pouches (DONOT TAKE OUT OF POUCHES) 5. placard is present and legible

1. FWD entrance compartment 2. flight deck 3. coat closet. 4. overhead bin (row 21 AC left)

4. on-off knob is fully off. 5. mask is in the bag, preattached to the oxygen bottle and hoses arenot cracked. 6. strap is attached and not frayed. 7. placard is present and legible

Placard is present. and legible

Verify straps are not frayed

Tamper proof seal is intact

Ensure tamper shield is intact

Placard is present and legible

Verify present

Must be sealed

FA1 checks

Verify present

Unfold and pull on straps

Must be sealed

Placard is present and legible

Check temperature tape and ensure it is not blackened

Found in Lavatory

It is a fire extinguisher

Remove cover

must be sealed

placard is present and legible

break tamper proof seal

Can be used by pax

1. Wheels are operable

2. There are no sharp edges on the carts

3. Drawers are operable

4. cart brakes must be set and in good working condition

3. Check lifeline is present and attached

4. make sure snap hook is present and attached to rope

5. cart door must latch properly

6. All exterior red safety latches are operable

7. Cart handles are not loose or broken

8. Flaps on waste cart must fully retract and close

securely mounted and in good condition

Squeeze black handle CHIRPING noise must be heard

check neck strap is attached (maybe coiled in a clear bag)

verify placard is present and legible

If no noise is heard check volume control and retest

Safe for use if BOTH silver tamper evident seals are intact

if ony 1 is missing/broken notify CA

if BOTH are missing check vsi/humidity indicator (MUST BE BLUE NOT PINK)

verify placard is present and legible

safe for use if 1 silver tamper evident seal is intact

extinguisher is securely mounted and in good condition

pressure gauge indicates in GREEN arc

safety pin installed with seal intact

hose is attached and unobstructed

verify placard is present and legible

verify placards are present and legible

ensure GREEN status indicator light is blinking

ensure AED is sealed (if no seal of broken, notify PIC and take inventory, if ALL contents are present reseal with seals in flyaway kit

Ensure RED status indicator light is blinking

Ensure AC power is on. GREEN LED is illuminated

Insert the long end of the testing pin into smaller hole next to the green light

confirm the alarm signal runs continuously while depressing switch

confirm that RED LED is illuminated on smoke sensor

Verify placards are present and legible

Ensure GREEN LED is illuminated

Sealed

Present

Verify tamperproof seals are intact

Ensure life vest is stowed in pouch

Placard is present and legible

Ensure there are 5 infant life vests in pouches

Check neck strap is attached

Securely mounted and in good condition

Press red button until the CLICKING noise is heard

check neck stap is attached (maybe in clear bag)

verify placard is present and legible

FA1 checks to see its present in FWD part of AC with plastic cover in place

FA 2 checks to see its present in AFT part of AC with plastic cover in place

verify placard is present and legible

report irregularities to CA

Check behind last row of AC LEFT (on all CRJ AC) to confirm all vents on bulkhead are closed

Check behind last row in AC RIGHT (on all CRJ AC) to confirm nothing has been placed inside the pannel on the floor

Report irregularities to CA

Verify placard is present and legible