Font size
WorksheetsMRV MCP Materials Common Parts and tools
Total questions: 17
Worksheet time: 16mins
Correctly match the following terms by dropping and dragging the term to the number definition.
1) Unit of measure for mass 2) Cubic Meter 3) multiplied by 1000 4) Unit of measurement for of a substance 5) Square meter (m2)
Kilogram
Volume
Kilo
Mole (mol)
Area
Correctly match the following terms by dropping and dragging the term to the number definition.
1) Unit of measurement for length 2) Unit of measurement of heat 3) Unit of Measurement for Electrical current 4) Unit of measurement for Luminous intensity 5) Unit of measurement for time
Meter
Kelvin
Ampere
Candela
Seconds
Reorder the following Correctly match the following terms by dropping and dragging the term to the number definition.
1) Meter per Second 2) One-ten-thousandth 3) Used to measure the outside diameter of an object 4) used to measure inside diameters, outside diameters and depths with precision
Speed
Milli
Micrometer
Caliper
The standard International (SI) units is a system of unified weights and measurements developed on basis of the metric system
True
False
Which of the following is NOT commonly used in fasteners and materials in the marine industry?
Wood
Rubber
Metals
Plastic
They are all commonly used
The screw threads on a nut are female
True
False
Pitch is the distance between threads
True
False
Most Nuts and bolts are single use
True
False
A double nut application is a good procedure to use when tightening a fragile or brittle material that cannot be harshly clamped
True
False
The size of a washer is based upon its inside diameter only
True
False
A bearing is a simple machine.
True
False
Which of these statements is Not True regarding gear
They transfer force
They are always circular or cylindrical in shape
They mesh with other parts
They change speeds
Which of the following statements is true regarding seals?
They can go in either direction
They are always reinforced with metal
High pressure or excessive wear areas require a single lip seal
They can be used in areas where a rotating shaft needs to pass through a section of the motor
Which of the following is a fastener found on outboard motors
Safety Clips
Circlips
Nuts and Bolts
Cotter Pins
All of these are used
Which of the following is the best tool to use to loosen a seized bolt?
Impact Driver
Lubricant
Hammer
Impact driver with a hammer
All of these
Which is the best tool to measure run out?
Caliper
Micrometer
Dial Gauge
Thickness Gauge
Which is the best tool to measure liquid or gasoline?
Beaker
Pressure gauge
Beaker and Pressure Gauge
DMM
Cylinder Gauge
