Which type of copper fitting requires solder wire to make the joint?

What type of fitting requires a swaging tool to make the joint?

What grade of copper tube is used for below- ground water supplies?

What type of bending machine is required to form bends in low carbon steel pipework?

Medium-grade LCS is identified by what colour coded banding?

Which of these are NOT a type of protection for LCS pipework

LCS is made from:

Statement: All grades have the same outside diameter, but the heavier the grade the smaller the bore.

What is the maximum recommended clip spacing interval for a 22mm vertical copper pipe?

The component shown here is:

The horizontal and vertical clipping distances for 15mm plastic pressure pipe is:

Sheradised type screws are:

Brass, Stainless steel and Zinc screws are beneficial of outdoor use due to:

What is the term used to work out how much copper tube is required, providing you know the centre-to-centre measurement?

LCS threads cannot be made using a:

PVCu soil and waste pipe comes in diameter sizes: 110mm, 50mm, 40mm, 32mm and...

When marking out, and before drilling, check for any buried pipes or cables using:

The length of joists is measured as:

Approved document A sets out requirements for notching is that a notch is ONLY cut within:

Approved document A sets out requirements for notching is that the depth of a notch must not exceed:

Approved document A sets out requirements for drilling is that any hole should be centre and within:

Approved document A sets out requirements for drilling that any hole must be at least 3 diameters away from each other and:

A pipe guard may be used in cases of notches to protect against:

The symbol shown here is:

The symbol shown here is:

The symbol shown here is:

The symbol shown here is:

The symbol shown here is:

A _______ show an area, generally the whole site so you can locate a specific property and the access to it

Site plans are generally drawn in a scale of: (select 2)

A ___________ details a specific property, showing dimensions of rooms, locations of windows, doors, guttering, soil pipes etc.

Buidling plans are drawn in a scale of:

Working drawings are drawn in a scale of:

Pipework in a BLUE identification coating is:

Pipework in a YELLOW identification coating is:

To accurately work out the length of pipe to be bent, the correct formula is?