The lowest members of a structure’s frame are __________.

The distance between two support points (posts, outside walls, columns, piers) is referred to as the __________.

Which of the following is not a purpose of the subfloor?

When installing joists, ensure that the crown points ________.

When installing a subfloor, the panels should be positioned so the joists are staggered.

Sill plates are normally made from __________ treated lumber.

Building code requires all lumber that comes into contact with masonry, concrete, or the ground to be __________.

This document lists the types and quality of materials needed for a job.

_________ is installed between joists to stiffen the floor frame and disperse the load to neighboring joists.

The most common framing system now in use is what system? (Also called western framing)

The most common spacing for floor joists in residential framing is _____ inches on center.

What are these?

What are these?

What is another name for a bottom plate?

What is this?

What is this?

What is this?

What is this?

The most common framing system now in use is what system? (Also called western framing)

The most common spacing for floor joists in residential framing is _____ inches on center.

What are these?

What are these?

What is another name for a bottom plate?

What is this?

What is this?

What is this?

What is this?

The joist that extends around the entire perimeter of a floor is called a:

What supports and transfers loads from windows to the wall and provides a surface to which the window can be attached?

What support an exterior finish and transfer wall loads to the wall framing members?

What Carry floor loads to supporting walls or columns?

What are horizontal structural members used to carry the floor and ceiling loads.

What is a horizontal structural member located at the bottom of the studs and used to hold the wall together?

What is the vertical framing member in frame wall construction?

What is a horizontal structural member located on top of the studs and used to hold the wall together?

What is a horizontal structural member used to support other structural members over openings, such as doors and windows?

The opening left in a framed wall for a window or door.

Studs are generally _______ stock.

Identify the Parts of the wall frame. #1

The framing member that goes vertically between the bottom and top plate

common spacing between studs

Small pieces that span between studs for attaching sheet rock.

Studs are generally _______ stock.