WorksheetsTable Saw, Drill Press, Sanders Quiz
Total questions: 16
Worksheet time: 42mins
The safest way to remove scrap pieces from around the revolving blade is to:
Turn off the power and wait for the blade to stop.
Use a push stick
Remove the stock being cut first,, before removing the chips
Both A and B
How high should the blade extend above the stock to be cut?
1/2 in
1 in
1/8 in
3/4 in
Before using a Table Saw, you should?
Ask for Instructor's permission
Remove all Jewelry, eliminate loose clothing, and confine long hair
Wear approved, sanitized safety glasses
All of the above
After drilling the drill bit:
will be dull and need to be sharpened
should be left in the chuck for the next person
will be hot
Small pieces of wood must be clamped
True
False
Which item(s) of protective equipment is/are absolutely necessary when operating the drill press?
Leather gloves
Leather apron
Steel toed shoes
Safety glasses
The chunk key is used for
Tightening the table
Tightening and loosening the chuck
Loosening the wood form the bit
Turning on the drill
Touching the chuck while it is spinning, is allowed:
Only when reducing feed pressure
Only when increasing feed pressure
Only when wearing gloves
None of the above
One of the common accidents that can occur on the drill press happens when:
the chuck key is left in the chuck
a drill bit is left in the chuck
the table height is not adjusted properly
the machine is being used without being turned on
While the sander is in motion, you should
keep your fingers away from the abrasive surface
remove the abrasive sheet
blow away the sawdust
use extreme feed pressure
Better result are obtained safely if stock is fed into the sander
at a fast speed
with gentle pressure
with extreme pressure
at a slow speed
When operating the disc sander, you should sand against the disc
rim
center
upward motion side
downward motion side
