WorksheetsUEAP Y1W1 Equipment Safety
Total questions: 19
Worksheet time: 12mins
Equipment Safety begins with the (a) .
It is recommended you read and understand this before using the equipment.
Operators Inspection checklist
Operators guidebook
Operators Controls
Operators Manual
Pre-Trip Inspections are done for the safety of the crew, general public and yourself?
TRUE
FALSE
Level Digger Derricks using the _____
Outriggers
Cribbing
Rigger Pads
Curb
Outriggers and Stabilizers are for (a) .
When angles are greater then 5% the truck should be operated at the ___ ___ of the swing pattern.
highest half
back half
lowest half
front half
Operational zones vary greatly between different types of vehicals.
TRUE
FALSE
The operator should always refer to the load angle charts before lifting loads with the boom.
FALSE
TRUE
A boom is at its strongest when its fully extended and at the lowest possible angle.
TRUE
FALSE
________ ________ have power takeoff (PTO) units similar to those on digger derricks
(a)
The booms of material handlers are designed for use in almost any combination of angles but only when the truck is level.
TRUE
FALSE
AC dielectric tests should be performed on the booms_______ to ensure they conform to ANSI standards.
annually
quarterly
bi-annually
every two years
Aerial lifts have _______ _______ near the turret to allow ground personnel to operate the equipment in the event of an incident.
(a)
Backhoes are used frequently by crews, safety is the responsibility of the ________.
Foreman
Lead
Operator
Safety Guy
When driving backhoes on roads, a slow-moving vehicle triangle should be affixed to the front.
TRUE
FALSE
Ensure all workers stay out of the swing radius of the backhoes ______ at all times until authorized to enter the work area.
hoe
arm
outrigger
bucket
When digging on slopes, spoils should be placed on the (a) side.
Locate marks for electrical power lines are colored
Blue
Green
Yellow
Red
Did you find this review helpful?
YES
NO
UNDECIDED
