WorksheetsCCNA - SRWE - 1.6.4
Total questions: 12
Worksheet time: 6mins
Which tasks can be accomplished by using the command history feature? (Choose two.)
View a list of commands entered in a previous session.
Recall up to 15 command lines by default.
Save command lines in a log file for future reference.
Recall previously entered commands.
Set the command history buffer size.
Which statement describes the system LED operation on Cisco Catalyst switches?
If the LED is amber, the system is not powered on.
If the LED is blinking amber, the switch is performing POST.
If the LED is amber, the system is receiving power but it is not functioning properly.
If the LED is blinking green, the system is operating normally.
What type of Ethernet cable would be used to connect one switch to another switch when neither switch supports the auto-MDIX feature?
crossover
coaxial
rollover
straight-through
What advantage does SSH offer over Telnet?
connection-oriented services.
more connection lines.
encryption.
username and password authentication.
A network administrator has configured VLAN 99 as the management VLAN and has configured it with an IP address and subnet mask. The administrator issues the show interface vlan 99 command and notices that the line protocol is down. Which action can change the state of the line protocol to up?
Configure a transport input method on the vty lines.
Remove all access ports from VLAN 99
Connect a host to an interface associated with VLAN 99
Configure a default gateway
Which statement describes SVIs?
An SVI is created automatically for each VLAN on a multilayer switch
A default SVI is created for VLAN 1 for switch administration
Creating an SVI automatically creates an associated VLAN
An SVI can only be created for the management VLAN
Which prompt is displayed when a network administrator successfully accesses the boot loader on a switch to recover from a system crash?
switch:
switch#
system#
system:
Which router bootup sequence is correct?
1- perform the POST and load the bootstrap program.
2- locate and load the Cisco IOS software.
3- locate and load the startup configuration file or enter setup mode.
1- perform the POST and load the startup configuration file.
2- locate and load the bootstrap program.
3- locate and load the Cisco IOS software.
1- perform the POST and load Cisco IOS software.
2- locate and load the startup configuration file or enter setup mode.
3- locate and load the bootstrap program.
1- perform the POST and load the bootstrap program.
2- locate and load the startup configuration file or enter setup mode.
3- locate and load Cisco IOS software.
What is the first action in the boot sequence when a switch is powered on?
load boot loader software
low-level CPU initialization
load the default Cisco IOS software
load a power-on self-test program
What must an administrator have in order to reset a lost password on a router?
physical access to the router
a crossover cable
a TFTP server
access to another router
When configuring a switch for SSH access, what other command that is associated with the login local command is required to be entered on the switch?
login block-for seconds attempts number within seconds
enable secret password
username username secret secret
password password
Which command will provide information about the status of all interfaces including the number of giants, runts, and collisions on the interface?
show interfaces
show ip interface brief
show running-config
show history
