When making a clutch adjustment, it is necessary to ______.

Technician A says the pressure plate assembly squeezes the clutch disc onto the flywheel. Technician B says the pressure plate moves away from the clutch disc so that the disc can stop rotating. Who is correct?

Technician A says the front of the transmission input shaft may be supported by a pilot bearing. Technician B says on some transaxles the input shaft is not supported by a pilot bearing. Who is correct?

Which of the following components is NOT part of the clutch disc?

Gears can _____.

Technician A says spur-cut gears have teeth cut at an angle. Technician B says spur-cut gears run without creating gear whine. Who is correct?

Which of the following gear ratio shows an overdrive condition?

Using a lubricant that is thicker than service manual specifications can lead to _____.

Manual transmission/transaxle lubricants in use today include _______.

Torsional coil springs in the clutch disc ______.

When the clutch is disengaged, the power flow stops at the ______.

When an idler gear is placed between the driving and driven gear, the driven gear ______.

The component used to look the main shaft (output shaft) and a speed gear together is the _________.

Technician A says helical cut gears have teeth cut at a 90-degree angle to the side of the gear. Technician B says helical gears run without creating gear whine. Who is correct?