The drawing that is typically drawn larger than scale is the​ _____.

On which drawing would you find the​ location, size, and spacing of anchor​ bolts?

The part of the drawing that shows information about​ scale, the date of the last​ revision, and the drawing number is the​ _____.

The type of framing typically used to counteract wind loads in​ hurricane-prone areas is​ _____.

In balloon​ framing, the second floor joist sits on a horizontal framing member called a​ _____.

In platform​ framing, settling can be minimized by using wood with moisture content of approximately​ _____ %.

Steel​ I-beams are​ _____.

The amount a framing member bends under load is called​ _____.

The horizontal framing members that make up the majority of the floor system are known as​ _____.

Before installing sill plates it is most important to check the foundation for​ _____.

When nailing joists to a sill or​ girder, use​ _____.

In a floor​ system, the trimmer joists and header form a​ _____.

Bridging is typically installed in the middle of a span or every​ _____ feet.

How many linear feet of sill seal and termite shield are needed for a foundation 26 ' wide and 36'long?

How many floor joists are required for a building 28 feet wide by 32 feet long if the joists are spaced 16 o.c. and there is a girder in the​ center?

How many sheets of

4×8

plywood are needed for a floor system that is 28 feet wide by 40 feet​ long?

The system that allows for thinner floor slabs with higher bearing capacities is the​ _____.

Supports placed under concrete deck forms until the concrete is cured are known as​ _____.

A metal trough that is embedded in a concrete floor and is used for electrical and telecommunication lines is referred to as a​ _____.