NEW
Font size
WorksheetsREC 102 Leaf Spring Replacement Quiz
Total questions: 15
Worksheet time: 8mins
What should be used to lift the frame and place jack stands under the frame and axle?
Screwdrivers
Floor jacks
Pliers
Hammers
Why is it important to alleviate weight on the shackle bolts before removing them?
To make them easier to remove
To prevent damage to the bolts
To ensure proper installation of the new leaf spring
To avoid injury
What should be done with the lug nuts after removing them from the tires?
Discard them
Reuse them later
Replace them with new ones
Sell them
How should the leaf spring bolts be driven out?
Using pliers
Using a mallet or hammer
Using a screwdriver
Using an impact driver
What should be done if the threads of the leaf spring bolts are damaged?
Reuse them
Replace them
Grease them
Sell them
What should be used to remove the shackle bolts?
Box end of a wrench and an impact driver
Screwdrivers
Pliers
Hammers
What should be done with the shackles if they are damaged?
Reuse them
Replace them
Grease them
Sell them
What should be removed from the affected leaf spring before replacing it?
U-bolts
Tie plates
Nuts
Washers
Where should the leaf spring clip be pointed when placing the new leaf spring onto the axle?
Towards the front of the trailer
Towards the back of the trailer
Towards the curbside of the unit
Towards the roadside of the unit
What should be done to assist in reinserting the u-bolt into the tie plate?
Use pliers
Use a hammer or mallet
Use a screwdriver
Use an impact driver
How should the tie plate nuts be tightened for the final tightening?
Using a torque wrench
Using pliers
Using a hammer
Using an impact driver
What should be done if using new or previously used bolts?
Grease the shaft of the bolt
Replace the bolts
Reuse the bolts
Sell the bolts
What should be used to seat the bolt back into the leaf spring hanger?
Pliers
Screwdrivers
Hammers
Sockets
Where should the eye bolt for the leaf spring be sitting when reinstalling the shackles?
Below the bolt in The Equalizer
Above the bolt in The Equalizer
At the same level as the bolt in The Equalizer
On the side of the bolt in The Equalizer
What should be done before completing the final torque spec tightening on the wheel lugs?
Lower the frame and remove the jack stands
Replace the lug nuts
Grease the wheel lugs
Sell the wheel lugs
