NEW
Font size
WorksheetsGQ_Design
Total questions: 15
Worksheet time: 8mins
Where is the best orientation of bedroom?
North
South
East
West
Which of the following material has the lowest thermal conductivity
Brick
Wood
Steel
Drywall
Which side of structure will be exposed to the sun for approximately 4 months
North
South
East
West
At what stage should you consider tropical design concepts
At the very onset, during pre design stage
Anytime during the design development stage
During cintract documenation
During schematic design stage
Masonry Chimneys for Residential Type Appliances. Masonry chimneys shall be constructed of masonry units or reinforced concrete with walls not less than_____mm thick; or of rubble stone masonry not less than 300 millimeters thick. The chimney liner shall be in accordance with this Code.
100
50
150
200
Masonry Chimneys for Low Heat Appliances. Masonry chimneys shall be constructed of masonry units or reinforced concrete with walls not less than ___ mm thick: Except, that rubble stone masonry shall be not less than 300 millimeters thick. The chimney liner shall be in accordance with this Code.
200
100
50
150
Under _____ of the Civil Code of the Philippines, the engineer or architect who drew up the plans and specifications for a building/structure is liable for damages if within fifteen (15) years from the completion of the building/structure, the same should collapse due to defect in the plans or specifications or defects in the ground
Article 1723
Article 1725
Article 1823
Article 1825
A roster showing the names and place of business of all registered professional architects shall be prepared and updated by the Board and copies thereof shall be made available to any party as may be deemed necessary.
Roster of Architects
Roster of Architecture
Roaster of Architects
Rosters of Architect
Exits shall be illuminated at any time the building is occupied with lights having an intensity of not less than ____ at floor level; Except, that for Group A Occupancies
10.7 LUX
10.5 LUX
12 LUX
10.8 LUX
Corridors and exterior exit balconies with dead ends are permitted when the dead end does not exceed ____meters in length
6.00
5.00
3.00
8.00
Required for exit door
Revolving door
Sliding door
Overhead door
none of the choices
shall be provided at the juncture of the roof and vertical surfaces
Flashing and counterflashing
Ridge rool and Capping
Drains and downsout
Fascia boards
shall be constructed as for attic area separations
Draft stops
Roof space
Roof Height
Attic roof
is a nonstructural facing of brick, concrete, tile, metal, plastic, glass, or other similar approved materials attached to a backing or structural components of the building for the purpose of ornamentation, protection, or enclosure that may be adhered, integrated, or anchored either on the interior or exterior of the building or structure.
Veneer
Venier
Vener
Venner
Chutes which are at an angle of more than ___ from the horizontal shall be completely enclosed on all four (4) sides, except for openings at or about floor level at each floor, for the receiving of materials or debris.
45 Degree
35 Degree
40 Degree
30 Degree
