wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Cooling Systems quiz

Total questions: 31

Worksheet time: 16mins

Name
Class
Date
1.

What is the term for the substance that forms when an engine does not reach operating temperature

a)

Sludge

b)

Scale

c)

Minerals

d)

slime

2.

What causes coolant to boil at normal peak engine temperature?

a)

The thermostat is defective.

b)

The pressure cap is defective.

c)

The cooling fan is not operating.

d)

The mix is 40% antifreeze and 60% water.

3.

A cooling system pressure tester installed on a cold engine reads 12 psi after five minutes of operation. The rad cap reads 12psi. What does this indicate?

a)

Excess Pressure Buildup

b)

Low pressure

c)

Leaking System

d)

System operating normal

4.

Coolant has bubbles forming in the filler neck of a cooling system immediately after an engine starts. What is the cause?

a)

Broken Fins on water pump

b)
Faulty radiator cap or malfunctioning pressure relief valve
c)

Bad head gasket

d)

Worn thermostat

5.

What test is performed by a cylinder of fluid and a suction bulb?

a)

Specific Gravity

b)

Pressure Test

c)

Coolant Acidity

d)

None of the above

6.

What is indicated by white exhaust smoke from a gasoline engine?

a)

Worn piston rings.

b)

Internal oil leakage.

c)

Internal coolant leakage.

d)

Low engine compression.

7.

What is checked first if a vehicle emits blue exhaust smoke?

a)

Engine oil level.

b)

Engine oil pressure.

c)

Fire.

d)
8.

An engine That never fully reaches operating temperature is usually caused by

a)

Stuck open Thermostat

b)

Stuck closed thermostat

c)

Thermostat that is rated at a much higher operating pressure

d)

Broken fins in the pump

9.

What tool is best used to check the thermostat

a)

Pressure tester

b)

Refractometer

c)

Hydrometer

d)

Infared thermometer

10.

What Type of pump is normally used in the cooling system

a)

Impeller

b)

Plunger

c)

Rotary

d)

Gear

11.

How much heat is removed by the cooling system

a)

13%

b)

33%

c)

43%

d)

66%

12.

Typical Pressure caps open at

a)

5-10PSI

b)

12-16PSI

c)

16-18PSI

d)

18-24PSI

13.

Combustion Temperature can reach ______F

a)

4500

b)

3500

c)

2500

d)

1500

14.

1.  What is a common cause of freeze or frost plug failure

     

a)

Engine Vibration

b)

Metal Fatigue

c)

Overheating

d)

Rusting

15.

A vehicle that overheats while idling but not while driving could be

a)

Stuck Thermostat

b)

Bad Belt

c)

Defective fan

d)

Clogged heatercore

16.

What is the first step when Diagnosing a bad cooling fan

a)

Check fuses

b)

Replace fan with a known good fan

c)

Check for power at the fan

d)

Supply power and ground to the fan connector pins

17.

What type of cooler in located in the radiator

a)

Oil

b)

Transmission

c)

Brake

d)

A/c

18.

Radiator tubes are made of

a)

Brass

b)

aluminum

c)

Plastic

d)

Aluminum or plastic

19.

What is shown by a combustion leakage test

a)

Coolant in the oil

b)

Oil in the coolant

c)

Exhaust smoke in the coolant

d)

Coolant in the exhaust

20.

What is caused by a stuck closed Thermostat

a)

Engine Overheating at all times

b)

Engine overheating while driving

c)

No heat to the passenger compartment

d)

Engine never reaches operating Temperature

21.

What controls the cooling fan

a)

A bimetalic strip

b)

A temperature sensitive sensor

c)

The ECM

d)

All the above

22.

A vehicle comes in running rough. The coolant temperature sensor is reading at -40C the likely cause is

a)

Sensor is shorted

b)

The sensor is open

c)

The Engine is frozen

d)

Low coolant level

23.

What radiator is better at cooling

a)

Downflow

b)

Crossflow

c)

Both are equal

d)

Depends on the application

24.

A customer comes in for a routine oil change. When removing the oil cap there is sludge found on the underside. The oil looks relatively clean. What is the cause

a)

Headgasket failure

b)

Failing to reach operating temperature while driving

c)

Fuel in the oil

d)

vehicle overheating

25.

What happens when engine temperature reaches above 204C

a)

Normal Operating condition

b)

Oil Begins burning in the crankcase

c)

the pump works faster

d)

None of the above

26.

Pressurizing a cooling system 10psi does what

a)

Lowers the boiling point

b)

Raises the boiling point

c)

Destroys the seals

d)

none of the above

27.

What is the function of the radiator cap in a cooling system?

a)

To increase the boiling point of the coolant

b)

To decrease the boiling point of the coolant

c)

To regulate the flow of coolant

d)

To filter the coolant

28.

What could be the cause of a coolant leak at the front of the engine?

a)

Faulty water pump

b)

Clogged radiator

c)

Stuck thermostat

d)

Defective cooling fan

29.

What is the purpose of the heater core in a vehicle's cooling system?

a)

To cool the engine

b)

To heat the passenger compartment

c)

To filter the coolant

d)

To regulate coolant pressure

30.

What is the primary function of a thermostat in a vehicle's cooling system?

a)

To cool the engine

b)

To regulate the engine temperature

c)

To increase the coolant pressure

d)

To filter the coolant

31.

What is the purpose of the radiator in a vehicle's cooling system?

a)

To cool the engine oil

b)

To transfer heat from the coolant to the air

c)

To increase the coolant pressure

d)

To filter the coolant