Font size
WorksheetsIT17 Steering & Suspension
Total questions: 20
Worksheet time: 20mins
A performance tire is found to have a nail in its sidewall. Which should be done?
Repair the tire with a patch from the inside.
Repair the tire with a string-type plug.
Replace the inner tube.
Replace the tire.
When replacing shock absorbers, the technician must guide the top of the shock absorber through a small hole in the frame or chassis. Which new component supplied with the shock should contact the metal part of the chasis?
Bolt
Nut
Rubber Bushing
Metal Washer
Which sensor sends information to the suspension control system to adjust ride height?
temperature sensor
crankshaft sensor
speed sensor
intake sensor
The owner of a vehicle complains that there is a squeaking noise coming from the front of a vehicle when the tires are turned from side to side. Which component should the technician inspect first?
drag link
front rotor
arm
upper strut mount
What part of the TPMS sensor most likely would require it to be replaced after six to eight years of service?
(a)
Technician A says that a tire pressure monitoring sensor inside the tire is the only way to check tire pressure. Technician B says the tire pressure monitoring sensor can be part of the valve stem. Who is right?
A only
B only
Both A and B
Neither A nor B
When replacing a tire pressure sensor on a vehicle with TPMS, what is the last step before reinstalling the tire on the wheel?
torque the sensor
program the sensor
remove the valve core
wrap the sensor with sealant tape
Technician A says that power steering pump pulleys may be pressed onto the pump. Technician B says power steering pump pulleys may be bolted onto the pump. Who is right?
A only
B only
Both A and B
Neither A nor B
When a tire is being mounted on a rim, it is important to match mount the tire on the rim:
to avoid damage to the tire.
so that the tire does not have to be rebalanced.
to help minimize the final combination of force variation and/or imbalance.
to avoid damage to the TPMS sensor.
After a power steering pressure hose has been replaced, it is important to:
bleed the system of fluid.
drain and flush the system.
pressurize the system.
purge the system of air.
A residual trace of oil is seen on the shafts of a vehicle's rear shock absorbers. The shock absorbers:
are normal.
are defective.
should be replaced immediately.
will need to be replaced within a few thousand miles.
Technician A says indirect tire pressure monitoring systems use the ABS to monitor tire pressure. Technician B says direct tire pressure monitoring sensors use a wired system to check tire pressure. Who is right?
A only
B only
Both A and B
Neither A nor B
Technician A says the power steering pump is usually driven by a belt. Technician B says some power steering systems do not have a pump and use an electric motor. Who is right?
A only
B only
Both A and B
Neither A nor B
After a technician has replaced one or all tire pressure monitor sensors, what should be done next?
adjust the tire air pressure
perform a relearn procedure
rotate the tires
test-drive the vehicle
Technician A says all vehicles have shock absorbers. Technician B says all shock absorbers support the weight of the vehicle. Who is right?
A only
B only
Both A and B
Neither A nor B
When replacing a sensor in a tire pressure monitoring system, what is the last step in the procedure?
performing a relearn
pressing the gas pedal three times
removing the tire
inspecting the module
What is a good practice to do when installing new tires?
Paint the rotors.
Paint the wheels.
Replace the lug nuts.
Replace the valve stems.
A vehicle has come into the shop with power steering fluid leaking from the hose area when the wheels are turned all the way in either direction. Which hose is most likely leaking?
return hose
bypass hose
forward hose
pressure hose
A worn strut assembly may result in:
a poor ride
noise while turning
unevenly worn tires
all of the above
What component is attached to the idler arm and pitman arm?
inner tie rod
outer tie rod
center link
track rod
