NEW
Font size
Worksheets217 PP3 sanitation Building Regulations Quiz
Total questions: 17
Worksheet time: 9mins
Which part of the Building Regulations is concerned with drainage and waste disposal in England and Wales?
Part 'N'
Part 'H'
Part 'G'
Part 'F'
What must all drainage systems in England and Wales comply with?
Environmental Standards
Building Regulations
Plumbing Codes
Health and Safety Guidelines
What is the focus of the H5 section in the Approved Document?
Solid waste storage
Separate systems of drainage
Building over sewers
Rainwater drainage
Why should you inspect the fascia boards before starting work?
To ensure they are painted correctly
To check if they are straight and level
To verify the color matches the gutter
To confirm they are made of the correct material
What could happen if the fascia boards are not straight?
The roof might collapse
The gutter can end up looking untidy
The paint on the fascia boards will peel off
The fascia boards will not fit properly
What should be used when using a ladder to prevent damage to brickwork or masonry?
A ladder stabilizer
A ladder stand-off
A ladder cushion
A ladder anchor
Before erecting a ladder on a lawn, what should be done to protect the grass and flowerbeds?
Water the lawn thoroughly
Cover the lawn with a tarp
Cover the lawn with a plywood sheet
Remove any nearby flowerbeds
Where should barriers be placed when plumbing work is being carried out?
Around the customer's vehicle
Around the entire property
Where work is being carried out to prevent injury
Only inside the work area
When installing gutter angle fittings, how far should stop ends and unions, fascia brackets be fitted from these fittings to provide additional support?
Within 50mm of either side
Within 150mm of either side
Within 250mm of either side
Within 350mm of either side
What is the first step in the gutter installation process according to the document?
Measure the overall length of the gutter
Establish the position of the outlet
Tie a string line on the first fascia bracket
Fix the first fascia bracket at the high position of the gutter
What should be done after establishing the high position of the gutter?
Measure the overall length of the gutter
Establish the position of the outlet
Tie a string line on the first fascia bracket
Fix the first fascia bracket at this point
How should the fall of the gutter be calculated?
Using a 1:200 fall
Using a 1:600 fall
Using a 1:400 fall
Using a 1:800 fall
What is the purpose of tying a string line on the first fascia bracket?
To measure the overall length of the gutter
To establish the position of the outlet
To ensure the gutter is level
To mark the high position of the gutter
When installing a running outlet on the fascia board, where should the weight of the string line hang?
Over the edge of the fascia board
Over the centre of the drain
At the end of the string line away from the outlet
Directly on the gully
How should the string line be secured around the running outlet?
Loosely to allow for adjustments
Tightly to show the fall and position of fascia brackets
With adhesive to keep it in place
Not secured, just placed
What is the maximum distance that fascia brackets should be secured apart in a non-windy location?
0.8m
1.0m
1.6m
2.0m
What should be the maximum distance between fascia brackets if the location is windy?
0.8m
1.0m
1.6m
2.0m
