WorksheetsForgotten TS quiz
Total questions: 20
Worksheet time: 4mins
Except what is permitted according to EV4.4.3, all parts belonging to the TS including
cables and wiring must be located within the (a) .
Select the incorrect points
Outboard wheel motors are allowed only if:
An interlock is routed along the TS wiring such that the SDC, is closed
before the TS wiring or its clamping fails.
TS wiring is not able to reach the cockpit opening or the driver regardless of where it
breaks.
Wiring outside of an impact structure or front bulkhead support structure
is longer than minimum length.
Minimum length is the shortest distance plus extra wiring caused by bending radius.
Pre-Charge Circuit is a circuit that ensures that the voltage at the vehicle side of the AIRs is pre-charged to at
least 90% of the actual TS accumulator voltage before closing the second AIR must be
implemented.
True
False
APPS is the acronym for:
(a)
The minimum static ground clearance of any portion of the vehicle, other than the tires,
including a driver, must be __ mm.
20
25
30
35
Fusing of the discharge main current path is prohibited.
True
False
The TSAL must be no lower than (a) mm from the highest point of the main hoop.
Any wet-cell battery located in the cockpit must be enclosed in a container, that is:
non-conductive
water
proof
acid resistant
impact resistant
The BSPD must open the SDC, when hard braking occurs, whilst ≥ __ kW of power is delivered to the motors.
3
4
5
6
The length of the complete endurance is approximately (a) km.
If the SDC is opened the TS must be shut down by opening all AIRs and the voltage in the
TS must drop to below 60VDC and 50VACRMS in less than ___ s. The action of opening the AIRs may be delayed by ≤ ___ ms
5, 300
10, 250
5, 250
10, 300
TS and LVS circuits must be physically segregated such that they are not running through
the same conduit or connector, except for (a) circuit connections.
What is the name of the marked sections?
(a)
The TSAL’s red light voltage detection circuit has to detect an
open circuit.
True
False
The difference between the maximum permitted voltage that may occur between any two electrical connections and the motor controller/inverters internal low power control signals is ___ VDC.
20
30
40
50
TSAL red light must be
illuminated for 1 s to 3 s for visible check after power cycling the
LVMS.
True
False
The TS power at the outlet of the TSAC must not exceed __ kW.
80
70
60
40
Parts of the vehicle which are or may become electrically conductive within ___ mm of any
TS component must have a resistance below ___ Ω to LVS ground.
(a)
The maximum cell temperature is (a) C or the limit stated in the cell data sheet, whichever
is lower.
The first __% of the brake pedal travel may be used to regenerate brake energy without
actuating the hydraulic brake system. The remaining brake pedal travel must directly actuate
the hydraulic brake system, but brake energy regeneration may remain active.
45
69
80
90
