NEW
Font size
WorksheetsN4/5 PWW - (Tool Box) Preparing The Blank
Total questions: 10
Worksheet time: 5mins
Why should square section material not be set up between the centres for turning?
It is potentially dangerous
It is too difficult to turn
It wastes too much wood
It takes too long to prepare
What tool is used to remove the four corners of the wood?
A plane
A saw
A chisel
A hammer
What is drawn across the corners at the end of each piece of wood to find the centres?
Curved lines
Vertical lines
Horizontal lines
Diagonal lines
What tool is used to draw a circle at each end of the piece of wood?
A ruler
A compass
A protractor
A square
What shape is drawn with its sides touching the circle at each end of the piece of wood?
An octagon
A square
A pentagon
A hexagon
What tool is used to remove the waste wood?
A file
A saw
A chisel
A plane
What tool is used to cut a diagonal groove at one end of the piece of wood?
A plane
A tenon saw
A file
A chisel
Why is a diagonal groove cut at one end of the piece of wood?
To remove waste wood
To make it easier to turn
To help the drive centre prongs grip the wood
To mark the center
What tool is used to hammer the drive centre into position?
A hammer
A mallet
A plane
A chisel
What is the final step before the wood is ready for turning?
Drawing a circle
Cutting a groove
Setting up the wood in the lathe
Removing waste wood
