The information needed to identify lines and other symbols on a construction drawing can be found in the _____.

Break lines are used to show that _____.

Which statement concerning symbols used on plans is true?

A dimension is a measurement written as a _____.

On a site plan, the scale may read SCALE: 1" = 20' 0". This means that _____.

The triangular architect's scale is the most commonly used because it _____.

Plans that show an aerial view of the building site location are called _____.

The materials to be used for the walls would be found in the _____.

What are engineered plans for motors, pumps, piping systems, and piping equipment called?

Which plans are also called plot plans?

There are three measurements that could be taken to get a pipe's dimensions.

The scale used to develop site plans is a(n) ____.

Which measuring scale is calibrated in units of 10?

Which type of construction drawing should you look at first?

The _____ on a drawing provides information about the structure or assembly and is numbered so the print can be filed easily.

An additional drawing that may be included in a set of drawings for public and residential buildings is a(n) _____.

If every one half inch on a drawing represents 1 foot, 0 inches, the scale would be _____.

The _____ on a drawing explains or defines symbols or special marks used in the drawing.

The title block on a drawing generally contains all of the following except a _____.

All of the following are elements of an architectural plan except _____.

All of the following letters are permitted in the gridline system of a drawing except _____.

P&IDs, schematic diagrams of a complete piping system that show the process flow, are included in the _____.

_____ define the quality of work to be done and describe the materials to be used.

Construction drawings were traditionally referred to as _____.

The _____ shows the materials to be used for the walls and include a framing plan.

A three-dimensional drawing that depicts the plumbing system is called a _____.

_____ are used on a drawing to tell what material is required for that part of the project.

_____ surround a part of a drawing that is to be shown in a separate cross-sectional view.

A(n) _____ is used to identify the location of a specific part of the drawing.