What is the maximum PSI capacity

What is the value of system rated capacity when both systems are ran

The A/M27T-16 is designed to check performance and operating characteristics of ____ systems without the necessity of starting of aircraft engines

The A/M27T-16 utilizes a _____ which manages the UHTS operations and provides diagnostic information

a _____ allows the operator the ability to interface with the PLC

The UHTS has a built in ______

The Purification system is a ____ design

The supply system ensures the ___ and ___ have a consistent supply of hydraulic fluid during open loop operations

What is the Reservoir's service level

Reservoir fluid level is determined using the ____ on the HMI

The Reservoir contains ___ to help prevent foaming of fluid

____ controls the flow of air in and out of the bladder

____ provides a barrier between atmospheric air and the clean air/fluid in the reservoir

____ is used to release the pressure from the reservoir before servicing the reservoir

____ is a electronic float that sends a signal to the PLC to display reservoir fluid level on HMI

The ____ portion of the check/relief valve will let atmospheric air enter the bladder when fluid level in the reservoir drops

The ____ portion of the check/relief valve will prevent the bladder from becoming over pressurized when the fluid level in the reservoir rises

____ prevents over pressurization of the reservoir by setting the maximum pressure to 15 PSI

____ is manually operated and is used to drain the reservoir or take a sample or fluid for test

____ is the access point to add hydraulic fluid to the reservoir

All pressure must be ___ from the reservoir before opening the fill cap

A hose can be attached to the reservoir shutoff valve to avoid ____

What is the purpose of the fill and bleed system

Each system must be ___ and ___ prior to operation

____ connects the UHTS reservoir to the full system

____ Fixed-displacement Pump that creates fluid flow for fill and bleed operations

____ Prevents over-pressurization of the fill system

Fill Relief Valve sets the maximum fill system pressure to?

The fill filter removes impurities down to ___ microns

Fill Filter closes when pressure rises to?

____ determines the path for fluid flow from the fill system to the main system

Both ____ prevent reverse flow of fluid from the main system #1 and #2 return lines into the full system

___ connects the full system to the return line in main system #1

___ connects the full system to the return line in main system #2

Fluid flows from the fill system into the return system and fills all components with fluid

____ primary purpose is to determine source of fluid for main system during main system operation

____ position allows fluid flow from the aircraft reservoir for main system operation

____ position allows fluid flow from the UHTS reservoir for main system operation

During fill & bleed operation the reservoir selector valve must be in ____ position to allow all components to be filled with fluid

Connection point ___ is the connection point to the purification system

___ is the highest point in the main system and air will collect at the top

Vent Valve is pressed at the same time as the ___ button on the HMI

____ is used to observe flow

Continue pressing vent valve and fill pump button until ___ fluid flow is observed in the sight gauge

The UHTS is designed to check performance and operating characteristics of aircraft ____ systems

The ___ is used to release the pressure from the reservoir before servicing

The purpose of the fill and bleed system is to remove ____ from all the lines, components and hoses

The ____ will generate all fluid flow for fill and bleed operations

The ___ an electrically actuated valve used to direct fluid into either system 1 or 2