NEW
Font size
WorksheetsTinkercad Circuits
Total questions: 15
Worksheet time: 15mins
A fifth grade class constructed this circuit. Which of these objects most likely made the light glow when connected to points X and Y?
plastic straw
cotton string
aluminum foil
rubber eraser
This image represents what type of circuit?
open
closed
series
parallel
What type of circuit is represented by the diagram?
closed
series
open
parallel
If bulb 1 burns out, what will occur?
bulbs 2 and 3 will go out
bulbs 2 and 3 receive more volts
bulbs 2 and 3 will stay lit
nothing will happen
A student builds a circuit made up of a battery, two light bulbs, and a switch. What will the student most likely observe in this circuit?
Light bulb 1 and light bulb 2 will both be on
Light bulb 1 will be off, but light bulb 2 will be on
Light bulb 1 and light bulb 2 will both be off
Light bulb 1 will be on, but light bulb 2 will be off
The diagram shows a series circuit with three lit bulbs. How many of the bulbs will remain lit if the wire is cut a the point shown by the arrow?
0
1
2
3
A group of students built the circuit shown above. The lightbulb does not glow. Which statement explains this observation?
The battery is not charged
The lightbulb is not part of a complete circuit
The circuit does not have a switch
The bell uses most of the energy from the battery
The diagram shows an electric circuit with four bells that a student plans to build. When the student connects the wire as shown, which of the bells will ring?
Bell 1 only
Bells 1 and 4 only
Bells 3 and 4 only
Bells 1, 2, 3, and 4
Is the following photo of an open circuit or closed circuit?
A closed circuit which allows electricity to flow
An open circuit which does not allow electricity to flow
Why won’t the light bulb in the circuit pictured to the right light up?
The wires from the second light bulb are not connected to the battery
The wires are not connected between the light bulbs
The wires are not connected to both sides of the first light bulb
The wires are too long to complete the circuit
What kind of circuit is this?
series
parallel
What is the primary function of a resistor in a Tinkercad Circuit?
To increase the current
To decrease the voltage
To limit the current
To store electrical energy
In Tinkercad Circuits, which component is used to store electrical energy?
Resistor
Capacitor
LED
Switch
Which of the following is a correct representation of Ohm's Law in a Tinkercad Circuit?
V=IR
I=VR
R=VI
P=IV
When simulating a Tinkercad Circuit, what happens if you connect an LED directly to a power source without a resistor?
The LED will light up normally
The LED will not light up
The LED will burn out
The LED will blink
