wayground logo

Free Printable Worksheets

NEW

Font size

S
M
L
XL
Worksheets

CHAPTER 6

Total questions: 10

Worksheet time: 5mins

Name
Class
Date
1.

What is the main purpose of a fullway gate valve in a plumbing system?

a)

a) To regulate water temperature

b)

b) To allow full water flow and shut off supply when needed

c)

c) To increase water pressure

d)

d) To filter out impurities

2.
  • Why must elevated or gravity storage tanks be tightly covered?



a)
  • a) To maintain water pressure

b)
  • b) To prevent water from evaporating

c)
  • c) To keep out unauthorized persons, dirt, and vermin

d)
  • d) To prevent overflows

3.

What device is required to control potable water inlets to gravity tanks?



a)

a) Gate valve

b)

b) Float valve

c)

c) Check valve

d)

d) Pressure regulator

4.

Which type of urinal requires the highest water supply fixture units (WSFU)?



a)

a) Wall urinal

b)

b) Stall urinal

c)

c) Pedestal urinal

d)

d) Flush tank urinal

5.

What is the purpose of the plumbing code’s sizing procedures?



a)

a) To ensure even water distribution and prevent pressure loss

b)

b) To reduce material costs

c)

c) To minimize the number of shutoff valves

d)

d) To eliminate the need for pipe insulation

6.

Why should control valves be installed before each water-supplied appliance?



a)

a) To regulate water temperature

b)

b) To isolate appliances for maintenance or repairs

c)

c) To improve water pressure

d)

d) To prevent contamination

7.

What is the first step in sizing a water supply piping system?



a)

a) Select the pipe material

b)

b) Determine the number of fixtures

c)

c) Measure the available water pressure

d)

d) Find the total pipe length

8.

What is the minimum mesh size required for screening a gravity storage tank vent?

a)

a) 10 to 12 mesh per 25 mm


b)

b) 12 to 14 mesh per 25 mm

c)

c) 14 to 18 mesh per 25 mm

d)

d) 18 to 20 mesh per 25 mm

9.

Which of the following factors affects the selection of the water meter size?



a)

a) The color of the piping material

b)

b) The number of shutoff valves installed

c)

c) The brand of plumbing fixtures

d)

d) Fixture unit demand

10.

Where should a shutoff valve be installed for each apartment unit?



a)

a) After the fixture trap

b)

b) Before the main supply line enters the unit

c)

c) Inside the water heater tank

d)

d) Near the floor drain